Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Made In Italy Letters Peeling Off.  (Read 2428 times)

0 Members and 1 Guest are viewing this topic.

The Happy Wanderer

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 283
  • Squeezing out Polkas on my Club Accordion.
Made In Italy Letters Peeling Off.
« on: August 17, 2015, 07:31:49 PM »

I noticed the little metal Made in Italy letters are peeling off the back of my Mundinger Diaton III. They were catching on my shirt, and they started bending a bit. I bent them back a bit, but they probably will keep bending/peeling. What do you recommend I do to fix it?

Logged
Mundinger Diaton III Grand Luxe C/F Club

The Happy Wanderer

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 283
  • Squeezing out Polkas on my Club Accordion.
Re: Made In Italy Letters Peeling Off.
« Reply #1 on: August 17, 2015, 07:57:06 PM »

I've got another picture. After playing another tune, it got bent again. I wonder what caused it to start bending in the first place?



Edit: I put a band-aid over the peeling part. This should work as a temporary fix.  (:)
« Last Edit: August 17, 2015, 08:57:04 PM by The Happy Wanderer »
Logged
Mundinger Diaton III Grand Luxe C/F Club

Broadland Boy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1243
  • Awful noises from Pokerwork, HA114G, BbEb Liliputs
Re: Made In Italy Letters Peeling Off.
« Reply #2 on: August 17, 2015, 10:39:17 PM »

You really need to flatten them so if you can gently lift the whole lot off, trap them between two bits of wood and flatten by squeezing in a vice (oops should really be vise over there  ;) ) or a couple of 'G' clamps, then de grease and re fix with a glue such as Araldite and hold in place with a couple of bits of masking tape, gently warming with a hair dryer will help the glue fill any remaining small gaps and hasten the glue cure.

Of course you could go the band aid route and be less enthusiastic with your playing, but I suspect that's about as likely as water flowing uphill anytime soon  ;D

Logged
Richard A
Venit ventus contrarius ventus egrediente,
Omnes prope quid ventum est circa

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Made In Italy Letters Peeling Off.
« Reply #3 on: August 17, 2015, 11:50:16 PM »

After playing another tune, it got bent again. I wonder what caused it to start bending in the first place?

You've answered your own question in your first post:

Quote from: The Happy Wanderer
They were catching on my shirt, and they started bending a bit....

Do what Broadland Boy suggests. It's not rocket science.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Graham Spencer

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3548
  • MAD as a wet Hohner........
Re: Made In Italy Letters Peeling Off.
« Reply #4 on: August 18, 2015, 04:35:49 AM »

Or don't wear a shirt.......
Logged
Among others, Saltarelle Pastourelle II D/G; Hohner 4-stop 1-rows in C & G; assorted Hohners; 3-voice German (?) G/C of uncertain parentage; lovely little Hlavacek 1-row Heligonka; Bâ™­/Eâ™­ Koch. Newly acquired G/C Hohner Viktoria. Also Fender Jazz bass, Telecaster, Stratocaster, Epiphone Sheraton, Charvel-Jackson 00-style acoustic guitar, Danelectro 12-string and other stuff..........

Squeezing in the Cyprus sunshine

The Happy Wanderer

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 283
  • Squeezing out Polkas on my Club Accordion.
Re: Made In Italy Letters Peeling Off.
« Reply #5 on: August 18, 2015, 11:33:31 PM »

You really need to flatten them so if you can gently lift the whole lot off, trap them between two bits of wood and flatten by squeezing in a vice (oops should really be vise over there  ;) ) or a couple of 'G' clamps, then de grease and re fix with a glue such as Araldite and hold in place with a couple of bits of masking tape, gently warming with a hair dryer will help the glue fill any remaining small gaps and hasten the glue cure.

Of course you could go the band aid route and be less enthusiastic with your playing, but I suspect that's about as likely as water flowing uphill anytime soon  ;D

Hmm. I will probably try this soon. I don't know if you can get Araldite in the US. Would any other Epoxy glue work?

How do you prevent the glue from getting in between the letters?  ???
Logged
Mundinger Diaton III Grand Luxe C/F Club

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Made In Italy Letters Peeling Off.
« Reply #6 on: August 18, 2015, 11:53:24 PM »


I don't know if you can get Araldite in the US. Would any other Epoxy glue work?

Araldite is just a brand name of epoxy resin glue. Any generic type would work, but perhaps don't go for an ultra-quick setting one (e.g. 90 secs or similar); you need a bit of time once you've mixed the resin and hardener to apply the glue and position the lettering into the correct place. A glue with, say, 5-minute setting time ought to be just fine.

Quote
How do you prevent the glue from getting in between the letters?
Just be careful. Use several small spots of glue applied with a cocktail stick to the back of the lettering strip, then press the lettering into place and hold firmly until the glue gels. Then use the pointed end of a fresh cocktail stick to pick off any excess glue which may have oozed out. If the glue is the sort which sets clear, a small amount of ooze is hardly going to be noticeable anyway.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

The Happy Wanderer

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 283
  • Squeezing out Polkas on my Club Accordion.
Re: Made In Italy Letters Peeling Off.
« Reply #7 on: August 18, 2015, 11:57:03 PM »


I don't know if you can get Araldite in the US. Would any other Epoxy glue work?

Araldite is just a brand name of epoxy resin glue. Any generic type would work, but perhaps don't go for an ultra-quick setting one (e.g. 90 secs or similar); you need a bit of time once you've mixed the resin and hardener to apply the glue and position the lettering into the correct place. A glue with, say, 5-minute setting time ought to be just fine.

Quote
How do you prevent the glue from getting in between the letters?
Just be careful. Use several small spots of glue applied with a cocktail stick to the back of the lettering strip, then press the lettering into place and hold firmly until the glue gels. Then use the pointed end of a fresh cocktail stick to pick off any excess glue which may have oozed out. If the glue is the sort which sets clear, a small amount of ooze is hardly going to be noticeable anyway.

Thanks! I guess I'll probably get the clear glue (I'm pretty sloppy.) :P

I guess that you press the letters to the celluloid? Or will there be a notch where the letters go?
Logged
Mundinger Diaton III Grand Luxe C/F Club

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Made In Italy Letters Peeling Off.
« Reply #8 on: August 19, 2015, 12:11:06 AM »

(I'm pretty sloppy.)
Then don't be. It's not a virtue to boast about. Just take care. Learn how your glue and tools work and respond - practice applying glue to small scrap objects first of all before tackling the real job.

Quote
I guess that you press the letters to the celluloid? Or will there be a notch where the letters go?
Always more questions...
If you think about it a bit I'm sure you could answer these for yourself, especially as you have the instrument in front of you.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

911377brian

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1518
Re: Made In Italy Letters Peeling Off.
« Reply #9 on: August 19, 2015, 08:36:32 AM »

. (:)
Logged

mr hohner

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 189
  • K.BLAND Melodeons
Re: Made In Italy Letters Peeling Off.
« Reply #10 on: August 26, 2015, 02:53:25 PM »

(I'm pretty sloppy.)
Then don't be. It's not a virtue to boast about. Just take care. Learn how your glue and tools work and respond - practice applying glue to small scrap objects first of all before tackling the real job.

Quote
I guess that you press the letters to the celluloid? Or will there be a notch where the letters go?
Always more questions...
Quote from: Steve_freereeder link=topic=17381.msg213285#msg213285
date=1439851816
After playing another tune, it got bent again. I wonder what caused it to start bending in the first place?

You've answered your own question in your first post:

Quote from: The Happy Wanderer
They were catching on my shirt, and they started bending a bit....

Do what Broadland Boy suggests. It's not rocket science.
If you think about it a bit I'm sure you could answer these for yourself, especially as you have the instrument in front of you.


 :o
Logged
Castagnari Studio D/G, Serenelli D/G, Hohner Pokerwork D/G, Castagnari Lilly D/G , Sandpiper Dublin II G/C, Serenelli Silyvia G/Acc

stevejay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 709
Re: Made In Italy Letters Peeling Off.
« Reply #11 on: August 26, 2015, 03:24:02 PM »

You adapted well to your 3 row from the 1 row. It's sounding good.
Fortunately you bought it to play not to fix  (:)
Logged

Sebastian

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1056
Re: Made In Italy Letters Peeling Off.
« Reply #12 on: August 26, 2015, 04:45:00 PM »

(I'm pretty sloppy.)
Then don't be. It's not a virtue to boast about. Just take care. Learn how your glue and tools work and respond - practice applying glue to small scrap objects first of all before tackling the real job.

Quote
I guess that you press the letters to the celluloid? Or will there be a notch where the letters go?
Always more questions...
If you think about it a bit I'm sure you could answer these for yourself, especially as you have the instrument in front of you.
;D ;D ;D 8)
Logged

savantuk

  • A Shropshire lad
  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 401
  • Location - Whitchurch, Shropshire.
Re: Made In Italy Letters Peeling Off.
« Reply #13 on: September 03, 2015, 11:28:31 PM »

Hmm,

I think I'd be tempted to cut my losses, and remove the badge, rather than try and repair and fix it using epoxy glue.  This is a PERMANENT solution, and were you to catch a corner again, you may just risk pilling off the badge together with a bit of the celluloid, which can be aa beggar to repair.

These things are usually held on with a sort of double sided tape, which will after a while lose it's adhesive quality.  Remove and then polish the celluloid, and all signs should be gone.

Charlie Marshall sells a better, more clothing friendly badge which is a good alternative (click the link, and scroll to the left to the made in Italy badge.):  http://www.cgmmusical.co.uk/CGM_Musical_Services/Badges_%26_Nameplates.html#10

CGM main site is here:  http://www.cgmmusical.co.uk/CGM_Musical_Services/Welcome.html

If you'd like one, and don't want the hassle of ordering one from CGM and import charges, I'll buy one, nd send it to you.

Good luck.
« Last Edit: September 03, 2015, 11:31:40 PM by savantuk »
Logged
Regards,

Doug

Castagnari Tommy D/G ~  Castagnari Max in C ~ Irish Dancemaster converted toy in C with Cagnoni reeds
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal