Sticky bellows as described is usually the result of a bit of excess glue which has oozed out from beneath the bellows tape. This causes the folds to stick together a little bit and makes that 'pfft' sound when the bellows are opened from a period of being closed up. It's annoying rather than a serious fault.
General accumulations of dirt and muck including spilled beer or similar can have the same effect

, so brush or vacuum out any muck and dust before proceeding further.
Remedy:
1. Make a dilute solution of dishwashing liquid (the sort designed for washing up by hand, not dishwasher detergent) in tepid water. The same sort of concentration as you'd use for washing dishes should be fine. Use a sponge which has been moistened in the solution and then well-squeezed out to clean around all the bellows tape edges in between the folds. A slight dampening of the bellows is all you need, hardly any wetness at all. For general stickiness, work all the way round every fold, but if the stickiness is confined to just a few folds then concentrate on those and leave the others alone.
2. Open up the bellows fully and place the instrument on a soft surface like a sofa or carpet so the bellows stay open. Allow to dry thoroughly for a couple of hours or so.
3. Puff some French chalk (ideal) or fine baby talcum powder (a good substitute)
sparingly on to a soft fluffy cloth or duster and apply to the sides of the bellows folds as you did with the detergent solution.
4. Brush off any excess powder using a clean duster, or vacuum off.
That should do the trick in most cases. If necessary, repeat the operation a couple of times, homing in on areas which you can hear/feel as being sticky. If the stickiness is not excessive, try just using the talc/French chalk method - steps 3 and 4. It may well work without resorting to dampening the bellows with the detergent solution.
It is also possible that the stickiness is occurring on the internal bellows folds, in which case remove the bellows entirely from both ends by pulling the bellows pins, being sure not to muddle them, so that the pins can go back in their original holes. Mark the inside of the bellows unobtrusively with a soft pencil to ensure you get it in the right orientation on reassembly. I would not recommend using the damp sponge on the raw card faces of the bellows folds. Instead, apply French chalk/talc liberally inside the folds. Open and close the bellows a few times and then
thoroughly vacuum out any excess to avoid getting powder in the reeds.