Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: My new Korg ot-120  (Read 1432 times)

0 Members and 1 Guest are viewing this topic.

Ronald Denis

  • Member
  • *
  • Offline Offline
  • Posts: 5
My new Korg ot-120
« on: November 12, 2015, 02:41:14 PM »

I just received the Korg ot-120
That is one beautiful tuner and, I especially like the orange
analogue needle.
Haven't figured out yet how I will use it to check the reeds on the accordions
as I also have to close one set of the middle reed bank...I think...
But I have checked it on my Edgley concertina and it is very sensitive as it picked up
 the C3 reed with absolutely no problem and held the needle .
Ronald
Logged

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: My new Korg ot-120
« Reply #1 on: November 12, 2015, 05:38:18 PM »

The trouble with the Korg OT120 (as far as I can see) is that whilst it is good at indicating the tuning if it is desired to tune 'at pitch', it is not so good at recording small yet important deviations away from 'at pitch' - the analogue needle scale is just not precise enough. There are only scale divisions at 10 cents intervals. For tuning tremolo, say to Dedic/Viennese tuning, you need to be able to read and tune to the nearest 1 cent (at the coarsest). Depending on which part of the pitch range you are working in, it can really make a difference to the tremolo rate if your tuning is out by a single cent.

If you are tuning one reed to absolute pitch M0 that's OK and then you can tune the tremolo reed by ear and count the beats. But for Viennese tuning it's important to know and tune to the accurate offset values of M- and M+, which for a nice sweet D/G Hohner sound typically might be in the range ±14 cents for the lowest notes to ±3 cents for the highest notes. This Korg tuner is just not precise enough to do that. Others may disagree, I expect. 

But - my Peterson tuner gives me digital readings to the nearest 0.1 cent and I normally accept tuning to within 0.5 cent of the required target, knowing that I am then approaching the stable limit of my set-up and equipment (differences in pressure on the tuning bellows being the most common source of error in this range).
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: My new Korg ot-120
« Reply #2 on: November 13, 2015, 08:42:26 AM »

Something I should have included in my previous post:

Tuning normally involves two steps: (a) measuring how far the existing tuning has deviated from the 'proper' target pitch and (b) tuning the reed by filing/scratching to bring the pitch to the target pitch.

If you are tuning on a tuning table with the reed blocks removed from the instrument, you need to be aware that the pitch of the reeds will almost certainly be different when sounded on the table compared with the pitch in the instrument. Typically this could be up to 5 cents sharp on the tuning table. So - if you are going to do your tuning with the reed block on the table (and it's very convenient to do this, in terms of access and manipulating the tools) you have to make allowances for the difference by 'tuning by offsets'.

Example:
1. Reed A4 (say) when sounded in the instrument is found to be 3 cents sharp. (therefore it will need flattening by 3 cents)
2. On the tuning table the reed A4 measures 8 cents sharp.
3. Therefore you need to flatten the reed until, on the tuning table, it sounds at 5 cents (8 cents minus 3 cents)
4. Then, once replaced in the instrument, the reed ought to be at, or very close, to 0 cents deviation.
5. A final tuning check has to be done always with the reed blocks in the instrument, and any further small deviations reiteratively adjusted until it's right.

This is, at a minimum, the sort of accuracy you need with your tuner and unfortunately I don't think your Korg with its coarse analogue scale divisions every 10 cents is going to give you that.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: My new Korg ot-120
« Reply #3 on: November 13, 2015, 09:55:17 AM »

I used a Korg OT120 (and it's predecessor the OT12) for a good many years as my only tuning meter, and during that time I built up an excellent reputation for my tuning work.  It is a very good tool, though as Steve points out there are now more accurate tuning tools readily available.  With practice you can learn to interpolate between the 0 and 10 cents on the display, and you will rely more on your listening skills.  So do not be discouraged from using your OT120  it will do the job, but as with all tools you have to work within it's limitations.   If what Steve had said was completely true then nobody would have been able to tune a box before the advent of strobe tuners!
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Malcolm Clapp

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1119
  • Loving my Hohner-reeded wet MMM CastaTommy
Re: My new Korg ot-120
« Reply #4 on: November 13, 2015, 11:21:00 AM »

Totally agree with Theo's sentiments. I began tuning with a Korg WT10 back in the late 1970s and updated to a WT12 when they first came out in 1979. Used it for years despite its comparative lack of visual accuracy, but you compensate for that by using the flappy things on the side of your head.
The only reason I stopped using the WT12 was that, with age, the screen began to get smaller. At least, I think that's what was happening! No such problem with APTuner on a 19" desktop PC screen though...my later weapon of choice in the workshop. Looks impressive too....and great to find a use for an obsolete Windows XP machine.
Logged
Tuner/repairer, now retired.

Ronald Denis

  • Member
  • *
  • Offline Offline
  • Posts: 5
Re: My new Korg ot-120
« Reply #5 on: November 14, 2015, 10:29:44 AM »

Thanks for the replies.
Whatever this tuner can do it is a lot better than what I had before
which is nothing.
For dry tuning it is probably as good as it gets.
I also noticed that to hear the beats  for wet tuning you can also play the fundamental note
on the tuner itself and compare it to the reed you are tuning or a single note instrument.
I tried it with my concertina and I could hear the slight beat on the notes that were off,  very little off.
Ronald
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal