Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Chanson D/G Air button problem  (Read 891 times)

0 Members and 1 Guest are viewing this topic.

JimmyM

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 103
Chanson D/G Air button problem
« on: November 20, 2015, 11:06:36 PM »

hello good people

I was having a play on my Chanson D/G tonight when it seemed to lose all 'compression' and it would barely make a sound. I guessed that the spring on the air button had broken. I took the panel off the bass side and that did seem to be the case.

I was very suprised at how the spring was held in place. It was held by a bent nail. Is this common or has it been repaired before? I intend to replace the nail with a split pin and will probably use a spare treble side pin that i have - i havnt checked yet but they look similar enough.

the bracket that the air lever pivots in was held down by four screws. I took those out and the bracket still didnt want to come out. i think its glued down. Does anyone know why this might be the case? In the end  i put the screws back and left it alone :-) Assuming my spring fits and the split pin works I dont think putting it back together will be a problem
Logged

JimmyM

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 103
Re: Chanson D/G Air button problem
« Reply #1 on: November 21, 2015, 03:33:42 PM »

Huge thanks to Theo for his advice on how to make my Hohner spring fit. My little baby is now up and running again :Ph. I had thought the general moaning about the quality of chinese instruments was a myth however after having mine apart Im thinking you get what you pay for :||:
Logged

Rob2Hook

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2278
  • Castagnaris, Hohners & Baffetti
Re: Chanson D/G Air button problem
« Reply #2 on: November 23, 2015, 01:27:59 PM »

Must be the quality of the bent nail - after all that's what Hohner use as the pivot link for every bass button!  After Hohner transferred Pokerwork production to China, the spring quality control became non-existant and a new box would go through half a dozen springs in six months and - having then eliminated all the defective ones - would have no further problems.  Mind you, no-one had tuned the thing at all.

I don't like the Pokerwork for reasons of the cheapskate way it's made and the same applies to the Chanson and every other badge name it goes under - but if you bear with it a while and fix a few things it should settle down.  Have heart!

Rob.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal