Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 2 3 [4]   Go Down

Author Topic: Club Modell II  (Read 11192 times)

0 Members and 1 Guest are viewing this topic.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Club Modell II
« Reply #60 on: January 18, 2016, 11:12:40 AM »

One weak point to check on many Hohner blocks is the glued joint to the sole plate at the end with the projecting toe.  The sole can begin to break away at this point.  I'm sure you would have noticed if it was badly cracked, but it is always work checking.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Adam-T

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1789
  • Hohner Corso
Re: Club Modell II
« Reply #61 on: January 18, 2016, 03:30:45 PM »

thanks Theo , thankfully the sole plates are in lovely condition (and flat) and well glued on :) .

Reeds cleaned and valved, one reedblock now waxed, not quite as smart a job as my past work (had a bit of clean up to do)  . I`ll use the smaller soldering iron on the others, it`s been a couple of years since I did this  ::)
Logged
Q: How do you cure MAD?
A: Buy more Boxes

Adam-T

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1789
  • Hohner Corso
Re: Club Modell II
« Reply #62 on: January 22, 2016, 01:43:08 PM »

Both treble blocks waxed and valved - second one went far smoother and didn`t need any clean up because I used the right soldering iron this time and was back in the swing (amazing what diff a couple of years out of the loop can do) .. BTW the blue marker on one reed denotes the Gleichton (so I know where it is)

I`ve got the bass blocks to wax and valve next week and then its a bit of tweak tuning in the treble (Trem difference is all it really needs) - the bellows gusset repair seems to be fine :D . after that it`ll be hopefully sorting the bits with Rob (Erika Kbd and Riser) and getting the box finished such as finalizing button height, sorting the air button (re-facing using thin stuff) , swivel Italian bellows straps and then unless the tuning needs intervention from a Pro - Enjoying :D .

Logged
Q: How do you cure MAD?
A: Buy more Boxes

Adam-T

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1789
  • Hohner Corso
Re: Club Modell II
« Reply #63 on: January 23, 2016, 12:38:59 PM »

I`ve got the treble end tuning in the ballpark , it only needed some tremolo levelling and it`s pretty much there - the two end Accs are a bit stuffy sounding so need to look into that .

But the Bass / chord blocks are now waxed and valved and in lovely tune so the box is almost finished .. I`ve enjoyed doing this slowly over a few weeks as a Project inbetween work rather than hammer on to get it done in a couple of days ..

Logged
Q: How do you cure MAD?
A: Buy more Boxes

Adam-T

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1789
  • Hohner Corso
Re: Club Modell II
« Reply #64 on: April 25, 2016, 02:08:30 PM »

Box now complete - I used Charlies rotating bellows straps with the nice 3-screw swivel ends and finished the Erika fingerboard like I did the "Relics" leaving some of the black behind ..

Fantastic box in sound and playing, I can see why Theo keeps one, this and the German ADG Corona-III will do me

Logged
Q: How do you cure MAD?
A: Buy more Boxes
Pages: 1 2 3 [4]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal