Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Maximizing reed responsiveness  (Read 2330 times)

0 Members and 1 Guest are viewing this topic.

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Maximizing reed responsiveness
« on: May 02, 2016, 12:01:05 AM »

I have hand finished reeds in a new accordion, I'd like more response from them - can they be worked over so the response is maximized, at a sacrifice in volume/durability, it seems?  This is a B/C/C#, my old Hohner Gaelic IVS speaks a lot more readily than the new one.  Probably I forgot to ask for the responsiveness when it was built, or are hand finished just inherently more sluggish than better grades?
« Last Edit: May 02, 2016, 02:44:32 AM by KLR »
Logged

melodeon

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1732
Re: Reed extreme makeover
« Reply #1 on: May 02, 2016, 01:35:39 AM »

"hand finished"  sounds like tipo a mano.. and not "hand made"
Logged

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Reed extreme makeover
« Reply #2 on: May 02, 2016, 02:43:18 AM »

"Hand finished" was the term the maker used, IIRC tipo a mano was the next grade offered - I'm away from my desktop machine and the emails.  Was thinking I was just missing out on the best tone.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Maximizing reed responsiveness
« Reply #3 on: May 02, 2016, 09:26:59 AM »

I've always viewed "had finished" as the same as "tipo a mano"  But if they are the next quality level below tipo a mano then there might be a little less scope for improving response.  I find that most new accordions have some scope for improving reed response, and after an initial playing in period the reeds will need adjusting and tuning again.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Maximizing reed responsiveness
« Reply #4 on: May 02, 2016, 10:20:16 AM »

The options I was given were "hand finished," and "hand made" for £400 more.  This is for 4 voices and 37 buttons.  I've been playing the box every day for about 3 months.

I searched for "hand finished" and "tipo a mano" and found this very helpful photo guide:  HANDMADE REEDS OR NOT? - Reyes Accordion & Bajo Sexto Forum  This piquing my curiosity, I decided to open up my box and see what the reeds show.  First thing I notice is the little handwritten note underneath the backpad showing the tuning ("DO-DO#-RE," C/C#/D), and "TIPO A MANO."  Had forgotten about that.  OK, clears that up.  Reeds inside look just like the ones depicted at the Reyes Forum too.

The other thing I notice, however, is that the screws that pass through the tabs that hold the blocks down are all about a centimeter out...what the hell!  So I screwed them back down and the box is playing like it should.  WHAT THE HELL!  Did I do that and forget to tighten them back up?  I honestly don't think so, I've mucked about with the couplers a bit but haven't opened up the treble side.  I did have the bass side worked on and maybe my tech loosened those screws and forgot to tighten them. 

Gods, I've been blowing my brains out for about 3 months too.  Thank Deity it was something thoroughly mundane like that.  No, I didn't work the screws loose through sheer force of playing.  That would be impressive.  They were all out the same length.  There's still a note here and there I wish would speak a titch more readily but just a titch.

 :Ph
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Maximizing reed responsiveness
« Reply #5 on: May 02, 2016, 10:40:07 AM »

  There's still a note here and there I wish would speak a titch more readily but just a titch.


That is something that could be improved by careful setting of the reeds.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

boxer

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 380
  • B/C Pokerwork - ultimate ceili box
Re: Maximizing reed responsiveness
« Reply #6 on: May 02, 2016, 01:08:11 PM »

I've always wondered why the response of otherwise identical pairs of reeds seems to depend on whether they're dry tuned or not.

I've referred to the setup of the reeds on my box in another place - they're MMM, two dry, one swing.  All three sets of reeds (when the stops are set to a single M) have identical response and feel.  The keyboard is the same in each case, of course.

Despite this similarity, the playing technique required for MM (swing) involves a lot less effort to start the reeds and get them to reasonable audibility than for MM (dry), and the swing pair are much more forgiving in terms of evenness of keystroke and pressure. Harder-to-reach notes that sound ok in swing demand a more precise attack and greater bellows pressure, when played on the dry reed pair.

My theory is that on a non-dry pair of reeds, the sound from the beat created by the interference of two dissimilar frequencies increases on a steeper curve than the sound from the actual reeds themselves.  A lot of what you hear is beat, above sound of the reeds themselves.  On dry reeds, there's only the plain sound of the reeds to hear.

Has anyone else noticed this and/or have any thoughts about it?


 

 
Logged
Nuage, Tommy, Cairdin, 
Double Ray DLX 21x12, Black Dot,
Pre-Erica, Pokerwork
plus various stringed things

forrest

  • Other Places::
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1009
  • digits still functioning
Re: Maximizing reed responsiveness
« Reply #7 on: May 02, 2016, 03:28:50 PM »

About 20 years back, I sent my first good melodeon, a Pokerwork, to an elderly tuner in British Columbia to have it tuned. I told him that I wanted it tuned dryer than the rather intense stock Hohner tremolo. He cautioned me that doing so would decrease the "power" of the reeds.
Logged

Railcot

  • New Starter
  • Offline Offline
  • Posts: 1
Re: Maximizing reed responsiveness
« Reply #8 on: May 02, 2016, 04:18:19 PM »

Suspect the no. of reeds activated on startup is the answer.(in part anyway)
The dry setup probably activates all reeds at once, the "wetter" sets ,slightly out of sync.
It should be easier for the flow of air to accomplish this.
It seems the same at the end of the note(chord etc.)  They don't sound as though they all finish at once,
although box resonance also comes into play
Having the audacity to say that as a non player (Newbie) I am sure other ideas will come forward from more experienced members.
I come from a Science background ,and there is some supporting theory.
Logged

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Maximizing reed responsiveness
« Reply #9 on: May 03, 2016, 01:49:42 AM »

This box is LMMH and I do mostly use the dry settings, so am making things a bit harder for myself, yes.  The MM is about 20 cents wet. 

Am going to get out my pane of glass and 2000 grit sandpaper and make sure the blocks are perfectly flat.  An old Paolo of mine had pretty concave bottoms.  This new box was a very tiny bit warped initially, too, was getting a bit of leakage when using the MM settings.  Green wood moves around a good deal.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal