Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Retrofit Helikon Basses  (Read 1878 times)

0 Members and 1 Guest are viewing this topic.

Mike Higgins

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 338
    • Strolling to Italy
Retrofit Helikon Basses
« on: June 26, 2009, 11:09:03 AM »

This is where I expose my lamentable lack of melodeon techie knowledge. Is it possible to retrofit helikon basses to a D/G pokerwork?

I'm not sure that just because it could be possible it would be desirable. The sound of those things is quite uhm  ??? 
Logged
Mike from Ponte Caffaro

HallelujahAl

  • Guest
Re: Retrofit Helikon Basses
« Reply #1 on: June 26, 2009, 12:59:27 PM »

The most obvious comment that I have to make is that Helikon bass reeds are big - the reed tongue alone being at least four inches long. Inside a small case like that of a Pokerwork it'd be a bit tight and possibly more importantly you'd have to consider the possibility of bellows and reeds interfering with each other. I experienced this with the first set of bellows that I made for a concertina. The folds were just slightly too large and the proximity to the reeds caused some problems.

However 'small' helikon reeds (if there is such a thing) may well be a possibility?
AL
Logged

Mike Higgins

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 338
    • Strolling to Italy
Re: Retrofit Helikon Basses
« Reply #2 on: June 27, 2009, 06:34:37 PM »

I notice on reading one of the wikis about Steirische harmonika that they say that the bell like tone of these instruments is given by a metal sounding board.
Logged
Mike from Ponte Caffaro
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal