Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: small dents  (Read 1042 times)

0 Members and 1 Guest are viewing this topic.

stevejay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 709
small dents
« on: October 07, 2016, 02:09:23 PM »

In woodworking I have heard that a wet cloth applied to a dent in certain woods, then applying a hot iron over the wet cloth will often cause wood to swell and remove a dent as water is absorbed.

I probably wont do this to a small dent on the case, but just wondering if anyone has experience with this

Thanks
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: small dents
« Reply #1 on: October 07, 2016, 02:26:40 PM »

Yes it can be quite effective in reducing the size of small dents in wood.  It can't replace any material that has been lost or rejoin any wood fibres that are broken. You also need to be prepared to repair the finish.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

stevejay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 709
Re: small dents
« Reply #2 on: October 07, 2016, 04:11:13 PM »

Thank you.
Logged

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: small dents
« Reply #3 on: October 07, 2016, 05:05:00 PM »

Yes - the damp cloth and hot iron method can work well. In a session at Whitby folk week just gone, someone pushed past someone else who was carrying a cello. The cello spike dug into the front face of my D/G Castagnari 1914 box and made quite an indentation. I was annoyed, to say the least...

However, back at the rented cottage later that evening, I used damp kitchen towels and a hot teaspoon heated on the gas hob to steam out the dent, restoring it flush to the surrounding wood surface. It worked very well and now the original damage is barely visible. You'd need to look very closely to see where it was.

Phew!  :Ph
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Andy

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 159
Re: small dents
« Reply #4 on: October 07, 2016, 07:55:44 PM »

Yes as has been said, provided it really is just a small dent, the hot iron and wet cloth should do the trick. Only thing I would add is if you have not done this before best to get a scrap piece of wood, put some dents in and have a trial run to build confidence and get technique perfected before you tackle the real thing.

Good luck
Logged

diatonix

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 622
Re: small dents
« Reply #5 on: October 07, 2016, 10:25:26 PM »

Careful with the hot iron! You dont want to add insult to injury... If the dent is minuscule, just apply a drop of hot water and allow whatever time is necessary. The real problem consists often in to how to deal with the varnish/wood finish. A) it may prevent the water/humid  from getting to where it's supposed to and B) in most cases it has to be repaired in a professional fashion after the dent itself has been successfully dealt with.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal