Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: One continuos reed plate and reeds.  (Read 816 times)

0 Members and 1 Guest are viewing this topic.

RPr

  • Member
  • *
  • Offline Offline
  • Posts: 28
One continuos reed plate and reeds.
« on: February 20, 2017, 11:04:07 PM »

I mentioned before, I have a an old Czech melodeon, perhaps from the 1950's or so. The reeds are not mounted to individual plates, the reeds are all mounted to a single long skinny plate.

This plate with the reeds attached is waxed in place, I assume over the sound holes. My tuner, set at A 440,  shows the notes to be the G# scale plus about 30 cents.

The melodeon was free (and worth every cent)    ;)   It is surprisingly in tune to itself, past the first four buttons and I can take a peek inside without worrying about ruining a fine old instrument.   Still it would be fun to make it play again I have a soft spot for neglected instruments. It might even be worth the effort to change out the reeds.
 
So the question is, can you still buy these reed plates with all the reeds mounted?
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: One continuos reed plate and reeds.
« Reply #1 on: February 20, 2017, 11:16:41 PM »

Yes you can, though not off the shelf.  But unless the reed tongues are broken it is unlikely you would need to replace them.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal