Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: reed scratcher from drill bit  (Read 3192 times)

0 Members and 1 Guest are viewing this topic.

Broadland Boy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1243
  • Awful noises from Pokerwork, HA114G, BbEb Liliputs
Re: reed scratcher from drill bit
« Reply #20 on: May 05, 2019, 08:02:53 PM »

any oblique angle that might be needed can be similarly 'gauged' - interested to see your comment on the superiority of the Arkansas stone Theo, what grain size is it compared to the diamond plate ?

For anyone without a variety of stones, a sheet or part sheet of 1000 or finer grit 'wet & dry' abrasive paper as used for car body repairs can be picked up fairly cheaply at any just about any Halfords type store, glued to a sheet of glass (aerosol contact adhesive is good) and used in the same way - I use this for final honing of plane blades.
Logged
Richard A
Venit ventus contrarius ventus egrediente,
Omnes prope quid ventum est circa

boxer

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 380
  • B/C Pokerwork - ultimate ceili box
Re: reed scratcher from drill bit
« Reply #21 on: May 07, 2019, 07:47:51 PM »

I used a Waschita stone for woodworking tools.  Not cheap, as I recall, but very very good.  I use the broken point of a narrow Swiss file to scratch reeds. 
Logged
Nuage, Tommy, Cairdin, 
Double Ray DLX 21x12, Black Dot,
Pre-Erica, Pokerwork
plus various stringed things

Kimric Smythe

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 712
    • Smythe's Accordion Center
Re: reed scratcher from drill bit
« Reply #22 on: May 09, 2019, 06:23:07 AM »

"Has anybody tried a lathe tool holder with a carbide interchangeable tip?"

The ones I have seen are too big, but that got me thinking about using a carbide tip from a saw blade and silver soldering it to a tool.
Logged
Smythe's Accordion Center
Pinole, California
Sales and repairs since 1997

Graham W

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 277
Re: reed scratcher from drill bit
« Reply #23 on: May 09, 2019, 12:24:30 PM »

I have made two, using 1.0 and 1.5mm solid carbide rod respectively. As a holder I use a brass rod about 5 inches long and pencil thick, turned down to a taper at the end to give max wiggle room between reed blocks and drilled for the carbide rod to be a snug fit in the hole.  At the other end is a reed lifter hook so the one tool can just be flipped around to either reed a lift or scratch it.

In reality the 1.5mm tool does everything. The carbide rod keeps its sharpness next to forever - just take great care not to drop it ! ;-(
Logged
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal