Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Corona reed layout  (Read 2397 times)

0 Members and 1 Guest are viewing this topic.

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Corona reed layout
« on: April 30, 2018, 09:12:06 PM »

My ADG IIIR's reeds are shared on various blocks, the one in the middle has the bass notes, etc.  Has anyone thrown together a chart of this?  I want to substitute a couple of notes, and it'd be a quick job to deduce where the reeds are, but wondered if anyone had done the homework already.

Along the same lines I found a few diagrams of Hohner bass notes that came in handy, those are a bit puzzling too, you can't just tape over a hole to kill a third without losing another chord's fifth.

The idea of having GDA instead of ADG is intriguing, too - there have been threads here about Borsini and Saltarelle boxes set up like that.  I play in G on the D row, on the pull, ala Irish box playing, and having the C on the outside row would be handier; and of course that G row couldn't be more muffled being on the inside, moved out to the outside it'd be a vast improvement sonically.  But this would be about as baffling a chore as they come, the way the reeds are all mix n' match on these blocks.
Logged

Conjunto Dave

  • Member
  • *
  • Offline Offline
  • Posts: 28
Re: Corona reed layout
« Reply #1 on: April 30, 2018, 11:19:46 PM »

I've also heard that the inner row (in your case the G row) can be muffled on the Corona IIIR. Try simply removing the grill and sound should be improved. I've know some players to replace the grill with a standard Corona II, III grill (with a little modification) to improve the sound of the inner row.
Logged

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Corona reed layout
« Reply #2 on: May 01, 2018, 01:11:52 AM »

I've tried that too, it's a common tactic with Irish box players.  Helps a bit.
Logged

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Corona reed layout
« Reply #3 on: May 07, 2018, 12:04:18 PM »

ADG pallet board layout.  I'd really like to have the G row in the middle - DGA - I break out in sweats trying to lay out where which reed goes where, though!   :o

Logged

MarioP

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 217
  • Enjoying the MADNESS
    • AnyITsolution.Services
Re: Corona reed layout
« Reply #4 on: May 07, 2018, 05:33:42 PM »

I've actually been thinkering of modifying mine too to DGC but the G row only has 10 buttons therefore the shared blocks will be short 1? get it.. I think that's what's throwing you off. It's pretty much 3 rows of reeds per one row ...that's why you'll see the 2nd row has a set of 10 and a set of 11 ( 20 and 22 ).. because that second block is shared with A and D (A having only 10 buttons and D having 11).. hope this helps..

you'll be shifting the reeds from your A blocks 1 and half of the second row over to your last 2 reed blocks (4 and 5 ) which is G...

you might need some refining for at least in my Corona II ADG the A row sounds a lot deeper than my G row and on my Pre Corona III my GCF the G row sounds a lot deeper than the F row... good luck..
Logged
Hohner Corso A/D x2, G/C, Corona II A/D/G from the 60s.
Hohner Pre Corona II BsEsAs,Club IV C/F Pre-War, Liliput C/F, Mignon I (G) Piano from the 30s, Kromatica III from the 60s harmonica. Hohner Kids I. Pearl Forum series 80s, Zildjian, Sabían, Wuhan cymbals. Ludwig snare 70s.

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Corona reed layout
« Reply #5 on: May 07, 2018, 11:40:17 PM »

Well, I notice that if the G goes to the middle row I'll have an extra button to deal with, I was thinking of adding a button for a lower note there if I can.  A more serious issue would be if I try to move the A row to the inside and the reeds are too large to fit on the blocks...I wonder if anyone has tried this.

The daunting part for me would be keeping track of which reed goes where, label each one "A1" "D1" "G1" etc. and hope I don't lose track somehow.

All of this is to deal with the terribly muffled inner row, too.  Grille off helps a bit.  New one from Hohner is $60 - would it fit?  Actually I have a pre Corona, a Trichord, a Venuzia...this makes me think of swapping headjoints on wooden flutes to see what happens.  Usually they just don't fit, of course...
Logged

MarioP

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 217
  • Enjoying the MADNESS
    • AnyITsolution.Services
Re: Corona reed layout
« Reply #6 on: May 08, 2018, 12:42:18 AM »

Since the A row is 10 buttons just like the G row you would be fine.

Remember that the side 11 holes on the second block are belonging o your D row which contains 11 buttons 😆 I don’t know the language but outter and inner rows are 10 buttons.

That’s why only half of the second reedblock has 11 holes because that’s the first set of reeds that compliments your third reedblok.

Then 4 and 5 are just G 😎

I was able to fit corona III reed blocks into my three voice preCorona but I had to sand down the length of all treble and bass reed blocks for they are longer on the corona iii.

My advise and observation after this swap with newer reeds from the 70s compared to the H reeds from the 30s and 40 is that those suqarish H reeds with the leather valves are just wayyyyyy to shut to let the air flow properly. I will be replacing the reed valves on my original H reed blocks expecting to have a better airflow than the current muffled inner row.

With the new reeds from the 70s it’s wayyyyyyyy louder with the plastic film valves...

I have a sample on my 40s H reeds https://youtu.be/K4olIZo9kQM
Another sample on the 70s T reeds https://youtu.be/M0rMIjhwlOo

Both recorded with the same phone different locations but indoors.
Logged
Hohner Corso A/D x2, G/C, Corona II A/D/G from the 60s.
Hohner Pre Corona II BsEsAs,Club IV C/F Pre-War, Liliput C/F, Mignon I (G) Piano from the 30s, Kromatica III from the 60s harmonica. Hohner Kids I. Pearl Forum series 80s, Zildjian, Sabían, Wuhan cymbals. Ludwig snare 70s.

KLR

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 640
Re: Corona reed layout
« Reply #7 on: May 08, 2018, 01:22:25 AM »

I'm worried about the size of the reeds because the notes on the A row are a fifth lower than those on the G, it seems like that would necessitate a long enough reed to where it might not fit on the block.  I have almost nothing but free time at work and will just label and measure things tonight, and see if this is really an issue.

I think I see what you're getting at - the middle block has only 10 holes on the "top" side and 11 on the bottom, and the bottom block has 11, so something will have to be sacrificed, which would of course be notes at the very top, I actually put them to use but if they have to go so be it.  But for now I think I'll just take the grille off.  Incidentally these IIIR grilles are way different than the III/II, don't know why I forgot that.  Maybe I could remove the mesh, or the coupler mechanism.
Logged

MarioP

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 217
  • Enjoying the MADNESS
    • AnyITsolution.Services
Re: Corona reed layout
« Reply #8 on: May 19, 2018, 10:05:28 PM »

I was watching some inside pictures of the
Corona IIIR seems like it’s only 3 reedblocks not 5 like I had thought it is.

So it might be even easier than I thought to do the swap or perhaps they come in 3 reedblocks and 5 reed blocks? Like the corona II and IIi but I’m not sure now.

This local tech was able to put a corona II grill on that IIIR I’ll try to ask him for the pic he also got rid of those register buttons and turned them into the same bass buttons instead..
Logged
Hohner Corso A/D x2, G/C, Corona II A/D/G from the 60s.
Hohner Pre Corona II BsEsAs,Club IV C/F Pre-War, Liliput C/F, Mignon I (G) Piano from the 30s, Kromatica III from the 60s harmonica. Hohner Kids I. Pearl Forum series 80s, Zildjian, Sabían, Wuhan cymbals. Ludwig snare 70s.
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal