Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Improving reed responsiveness?  (Read 1367 times)

0 Members and 1 Guest are viewing this topic.

Ribs

  • Member
  • *
  • Offline Offline
  • Posts: 29
Improving reed responsiveness?
« on: September 03, 2018, 09:02:50 PM »

Hi all. I'm looking for some advice on how I can improve reed responsiveness when switching between push and pull on the same button (treble side). I've got an older Hohner Pokerworks in G/C. There's quite a bit of problematic lag, to the point where I've learned to switch rows for fast note changes when I can to avoid switching bellows direction. It's old enough that it was still produced in Germany, but new enough that it has a plastic fingerboard, so I'm guessing maybe late 50's or early 60's? It's got synthetic valves, but those may have been replaced in the past. One or two valves are very slightly curled because it wasn't stored properly before I got it, but I can't imagine that they're bad enough to be the source of my problem. The bellows are still air-tight and I'm not getting any noticeable leakage anywhere. So my question is, aside from valves or leaky bellows, what might cause the issue? If you need any pictures of anything, just say the word and I'll see what I can do. Thanks.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Improving reed responsiveness?
« Reply #1 on: September 03, 2018, 09:24:30 PM »

Reeds can be adjusted for optimum response for your style of playing.  To do this you bend the reed tongue, usually downwards, by a very tiny amount until you find the optimum position. You will read in various places that the correct position is where the gap under the reed tip equals the thickness of the reed at the tip.  I think this is at best a very approximate guide.  Different makes and qualities of reed need different gaps, and the only way to get the optimum set is by trial and error on a tuning fixture.  It’s a skilled task best learned on an unimportant instrument.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Tone Dumb Greg

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4955
    • Dartmoor Border Morris
Re: Improving reed responsiveness?
« Reply #2 on: September 03, 2018, 09:34:33 PM »

... It's got synthetic valves, but those may have been replaced in the past. One or two valves are very slightly curled because it wasn't stored properly before I got it, but I can't imagine that they're bad enough to be the source of my problem....

Not directly on topic, but a question prompted by the original post. What is the right way to store a little used instrument to stop this happening?
Logged
Greg Smith
DG/GC Pokerwork, DG 2.4 Saltarelle, pre-war CF Hohner, Hohner 1040 Vienna style, old  BbEb Hohner that needs a lot of work.

ACCORDION, n. An instrument in harmony with the sentiments of an assassin. Ambrose Bierce

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Improving reed responsiveness?
« Reply #3 on: September 03, 2018, 09:42:14 PM »

I don’t think it matters with melodeons and accordions.  Concertinas are different because the valves are made of softer leather and will droop if left on one end. 
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Ribs

  • Member
  • *
  • Offline Offline
  • Posts: 29
Re: Improving reed responsiveness?
« Reply #4 on: September 03, 2018, 09:43:17 PM »

... It's got synthetic valves, but those may have been replaced in the past. One or two valves are very slightly curled because it wasn't stored properly before I got it, but I can't imagine that they're bad enough to be the source of my problem....

Not directly on topic, but a question prompted by the original post. What is the right way to store a little used instrument to stop this happening?

From what I understand (I'm relatively new to this, so don't take my word over anyone else's here), almost all accordions are designed to be stored in an upright/vertical position to help prevent valve curling. They usually have little "feet" on the bass side that they're intended to sit on. Also, as with any instrument, you'll want to store them in an area with no extreme temperatures or changes in humidity. Accordions are especially susceptible to these things because of the internal wax.

It’s a skilled task best learned on an unimportant instrument.

Forgive my ignorance here, but I assume that bending the reed in such a way could also potentially knock the tuning all out of whack, right? I won't be attempting it on my Pokerworks because it's somewhat of a family heirloom, I'm just curious.
Logged

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Improving reed responsiveness?
« Reply #5 on: September 04, 2018, 12:42:36 AM »

Forgive my ignorance here, but I assume that bending the reed in such a way could also potentially knock the tuning all out of whack, right? I won't be attempting it on my Pokerworks because it's somewhat of a family heirloom, I'm just curious.
Adjusting the reed tip gap does have a slight effect on the tuning:
Making the gap narrower tends to sharpen the pitch slightly and widening the gap tends to flatten the pitch. This is why it's best to optimise the gap before final fine tuning is commenced.

Also:
1. A gap set too wide will result in a louder, rougher sound, and will be breathy and slow to start.
2. A gap set too narrow will be weaker in sound volume, be more susceptible to pitch variations with bellows pressure changes. It may also be hesitant to start in a different way or 'feel' to (1) and if too narrow, may stop sounding altogether ('choke off').

As Theo has mentioned, the adjustment to find the optimum position is usually very tiny and delicate; often the difference is barely noticeable to the eye. It requires patience and practice to get it right, but is definitely worth doing.

Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal