Just a small point which may or may not be of use. I had several broken bass buttons on my Pokerwork, so bought a new set. They pull off the rods, which are actually stamped from sheet. I didn't notice before fitting the new ones, so can't make a recommendation based on practical experience, but... The new buttons come with a round hole drilled in the centre and are tapped down onto the rectangular section "rod" BUT the shoulders which set the full depth of insertion are not level so it is easy to get the new buttons askew. I would suggest filing down the higher should to match the lower one. I can't tell you how p*ssed I was to have one of my new buttons also p*ssed! (one tap too many with the toffee hammer)
Rob.