Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Lever bending tools  (Read 2970 times)

0 Members and 1 Guest are viewing this topic.

Broadland Boy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1243
  • Awful noises from Pokerwork, HA114G, BbEb Liliputs
Re: Lever bending tools
« Reply #20 on: December 11, 2018, 07:19:13 PM »

Yes mild steel is soft and can’t be hardened by heat treatment.  I think you will find that it bends too easily,  or you have to make the tools of inconveniently thick sections.
The clue is in the generic description “tool steel”

Theo, do you use your silver steel benders fully hardened or do you temper them down ?

Roger Silver steel is easily fileable in its raw state then glass hard (i.e. potentially brittle) when hardened but that can be let down by tempering, a lot of clockmakers and model engineers hand file profiled cutters for gears etc, harden by water quenching then either temper in something like a fat fryer or reheat until the right oxide colour appears then either oil or water quench, which depends on wind direction, sock colour, you get the picture........

Also known as Stubbs steel, if you find any so stamped grab with both hands and open wallet

Best you can do with mild steel is caseharden which results in a few though of very hard surface - not something we need for this but might come in handy for a reed scratcher in a push.
Logged
Richard A
Venit ventus contrarius ventus egrediente,
Omnes prope quid ventum est circa
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal