Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Silent reeds on a Hohner 114C  (Read 1278 times)

0 Members and 1 Guest are viewing this topic.

Gareth Sprack

  • Member
  • *
  • Offline Offline
  • Posts: 22
Silent reeds on a Hohner 114C
« on: March 16, 2019, 11:05:59 PM »

Hi all, I have three reeds that have gone silent on my 40 year old Hohner 114C, one just on blow and the other in both directions, as I can't hear anything rattling inside I am assuming they are not broken.  So what happens if I pull the fixing pins on that side to look whats going on, will I wreck the instrument or is it fairly simple to take a side off and replace it.  I am not in a position to afford professional repairs, so I will play the thing till it dies, if it is not an easy fix.

Gareth
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Silent reeds on a Hohner 114C
« Reply #1 on: March 17, 2019, 07:37:55 AM »

If the reeds are broken you can usually hear air blowing through where the reed was.
You can work out which bank of reeds by playing with just one stop open.  Check each stop. 
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Silent reeds on a Hohner 114C
« Reply #2 on: March 17, 2019, 08:40:27 AM »

Silent reeds are just about the most common fault that can affect a melodeon. Nearly always it is due to a piece of dirt or sometimes a hair which has got sucked into the tiny gap between the reed tongue and the reed plate slot.

As Theo says, you need to identify which bank of reeds has the problem. Use the stops one at a time to find this out. Sometimes the offending reed can be coaxed into playing again by sudden puffing of the bellows while holding the appropriate button down. This can dislodge the dirt/dust. Usually though, this doesn't work and you will have to open up the instrument.

To access the inside, you need to pull out the bellows pins using pair of pliers with a straight perpendicular pull. It's good practice to lay the pins safely in order, so that you can return each pin to it's original place on reassembly. This isn't so critical with Hohners but Italian pins can be slightly different diameters.

Having opened up the box, you will see the four blocks with the reeds mounted on them. The push reeds are the ones visible on the outside of the reed blocks, the pull reeds are underneath and covered by the leather or plastic valve. Each each reed block is controlled by one of the stops. You will need to identify which reed block contains the offending reed and which reed it is. Each reed plate is activated by one of the buttons.

If the silent reed is a push reed, try gently 'pinging' the reed tongue a couple of times with a thin knife blade (scalpel or similar) or a feeler gauge. This will usually clear the dirt or dust. If you can see a hair, use tweezers to remove it. (Cat hairs often seem to find their way into the reed blocks!).

If the silent reed is a pull reed on the underside of the reed plate, it is a bit more awkward to get to. Use a cocktail stick to gently lift the leather/plastic valve a little bit and then push the cocktail stick down through the slot until you feel it resting on the reed tongue. Gently ease the reed tongue up and down a few times. This should clear any debris.

Reassemble the instrument and try it out. If there are still silent reeds you may need to repeat the process.

Sometimes a reed will become silent if it has too narrow a gap between the reed tongue and the reed plate. In this case the reed tip gap will need to be reset by careful bending of the reed tongue. This is a delicate job (especially on the tiny high pitched reeds) and, for an inexperienced person, best left to a proper repair person. The gap has to be just right for optimal performance.

I am not in a position to afford professional repairs...
I don't think this would be an expensive repair. Where are you based?
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Gareth Sprack

  • Member
  • *
  • Offline Offline
  • Posts: 22
Re: Silent reeds on a Hohner 114C
« Reply #3 on: March 17, 2019, 08:44:24 AM »

The third stop (away from the player) top button (towards the stops) is silent on both push and pull. The second stop, second from bottom button is silent on the push.
If taking that end off is a relatively simple job for the amateur, that would give me the chance to see what is going on with the reeds, see what meat is available to re-fit the front grill and perhaps fit a loop for a shoulder strap.  If there is no real danger in carefully taking the end off the instrument I will give that a try, for the above reasons.  If I don't have any success or not confident to go too far, there is a well respected accordion repairer, not very far from me, I am based on the Isle of Wight.
« Last Edit: March 17, 2019, 09:15:46 AM by Gareth Sprack »
Logged

malcolmbebb

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2628
  • In dampest Dorset, on the soggy south coast.
Re: Silent reeds on a Hohner 114C
« Reply #4 on: March 17, 2019, 09:43:15 AM »

There is no great shortage of melodeon playing Morris musicians on the Isle of Wight so if you need moral support you shouldn't need to look too far.  :||: :M :||:
Logged
Dino BPII.
"Tradition is not the worship of ashes, but the preservation of fire."

Gareth Sprack

  • Member
  • *
  • Offline Offline
  • Posts: 22
Re: Silent reeds on a Hohner 114C
« Reply #5 on: March 17, 2019, 10:19:13 AM »

There is no great shortage of melodeon playing Morris musicians on the Isle of Wight so if you need moral support you shouldn't need to look too far.  :||: :M :||:

Your right there, my sister plays accordion for Bloodstone Border Morris, she thinks the melodeon is too complicated.
I have been trying to pin down one of their members for months.
Logged

Henry Piper

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 368
Re: Silent reeds on a Hohner 114C
« Reply #6 on: March 17, 2019, 10:43:27 AM »

For most of us these sort of jobs are part of everyday maintenance, and you shouldn't fear them, providing you take sensible precautions and are careful, opening up your melodeon should pose no risk. most melodeons especially Hohners are a great deal sturdier than you would imagine. !!
Logged
From Ottery St Mary Devon. Currently Playing Dino Baffetti BP2 in D/G, Hohner Student 1 P.A conversion  in D/G,  Hohner 3515 Pre-Pokerwork in A/D,   2 row "Beaver Brand" in Bb/Eb, Hohner Pre- Erica in G/C .  Single row permanent 4 voice, 4 bass in C from old Hohner single row and bits of a cheap Cajun box !!,

boxcall

  • You got to love it!!!
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1801
Re: Silent reeds on a Hohner 114C
« Reply #7 on: March 17, 2019, 03:13:26 PM »

The third stop (away from the player) top button (towards the stops) is silent on both push and pull. The second stop, second from bottom button is silent on the push.

So the reeds will be in standing block (two middle banks).
Should be easy for you to check them out, good time to check over the reed valves too.
Every old melodeon I’ve got has needed internal cleaning dust and or attic smells, spring cleaning!
Logged
Hohner 1040 C, Beltuna one row four stop D, O'Byrne Dewitt/ Baldoni bros. D/C#, Paolo soprani "pepperpot" one row D

Gareth Sprack

  • Member
  • *
  • Offline Offline
  • Posts: 22
Re: Silent reeds on a Hohner 114C
« Reply #8 on: March 17, 2019, 05:50:12 PM »

Thank you one and all, I shall have a look inside and see what I can do, if I run into trouble I shan't hesitate to shout for help on here, happy in the knowledge you good folk will answer.

Gareth
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal