Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 ... 8 9 10 11 12 [13]   Go Down

Author Topic: Building a one row four stop  (Read 47289 times)

0 Members and 1 Guest are viewing this topic.

boxcall

  • You got to love it!!!
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1801
Re: Building a one row four stop
« Reply #240 on: April 27, 2021, 11:25:26 PM »

Thanks Steve
I have 2 layers in there already and I can just barely get the buttons and pallets passed it when assembling. And even if I did, this would leave my buttons slightly proud of keyboard when pressed down. I’ll probably bend curing two problems ( buttons are slightly high and the pallet lift) maybe three ( springs could be a tad tighter).
Hopefully I’ll return with good news (:)
I got around to this as seen and with advice here http://forum.melodeon.net/index.php/topic,22965.msg274538.html#msg274538
I pulled the pallets , adjusted the button height (lowered) and reattached the pallets.
this improved the spring tension but still it was very light so I followed the above thread.
Tension is way better after removing four coils, I can always go more later.
Pallet lift is less, so less return noise but slight volume loss , more noticeable when playing MM only.
Button height is less, some might like it even more? Similar to Beltuna now.
Logged
Hohner 1040 C, Beltuna one row four stop D, O'Byrne Dewitt/ Baldoni bros. D/C#, Paolo soprani "pepperpot" one row D
Pages: 1 ... 8 9 10 11 12 [13]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal