Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Curious note rattle/pitch change  (Read 1121 times)

0 Members and 1 Guest are viewing this topic.

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Curious note rattle/pitch change
« on: March 18, 2019, 05:05:29 PM »

The lowest L reed on a 4-stop box is making a curious rattling sound, and sudden change in pitch, on the pull. I assumed it was an issue with the valve so I removed the reedplate and replaced the valve, but the problem persists. I made sure the reed moves freely, the reed is securely riveted to the plate, the reedplate is securely fastened to the reedblock, etc. I even removed the reedplate and set it up on a spare block on bellows to see if I could re-create the problem, and I could not. It will only happen when in situ.

I’ve attached a link to a soundfile demonstrating the problem. The reed will sound fine when played quietly. As I pull harder, the reed will suddenly begin to rattle and then change pitch. If I the pull even harder it begins to sputter! In the soundfile I am demonstrating how different bellows pressure affects the sound of the reed (you will be able to hear when I pull harder). Any ideas? Is it possible the reed tongue is hitting the back of the chamber? I’m stumped!

https://www.dropbox.com/s/tkbokgs9l5j8btb/L%20Note%20Rattle.m4a?dl=0
Logged
C#/D player

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Curious note rattle/pitch change
« Reply #1 on: March 18, 2019, 05:09:35 PM »

It’s the edge of the reed tongue making contact with something, or possibly glue spread from the valve onto the edge of the reed tongue.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Re: Curious note rattle/pitch change
« Reply #2 on: March 18, 2019, 05:24:15 PM »

I had looked inside the reed chamber to see if there was an obstruction, seen a glob of wax that I had assumed was the culprit, cleaned it out, but no luck.  Because it is a low bassoon reed, with a weighted tip, could the swing be such that it is hitting the back of the chamber? And if so, is there a solution?
Logged
C#/D player

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Curious note rattle/pitch change
« Reply #3 on: March 18, 2019, 05:35:50 PM »

It doesn’t sound like the noise of a reed tip hitting the chamber wall,  but maybe it is.  Try making the chamber walls a little higher.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

playandteach

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3526
  • Currently a music teacher in a high school.
Re: Curious note rattle/pitch change
« Reply #4 on: March 18, 2019, 05:41:02 PM »

A few years ago I had a low reed hitting the next block. It was travelling a long way, and Theo cleverly tipped the blocks away from each other to give it more room. It needed a quality machine to sand the angle whilst keeping the bottom of the block flat - I don't think I would have had the skills to do this by hand.
It might be worth a look at how far that reed can move if given enough air.
Logged
Serafini R2D2 GC, Serafini GC accs 18 bass

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Re: Curious note rattle/pitch change
« Reply #5 on: March 18, 2019, 06:00:55 PM »

A few years ago I had a low reed hitting the next block. It was travelling a long way, and Theo cleverly tipped the blocks away from each other to give it more room. It needed a quality machine to sand the angle whilst keeping the bottom of the block flat - I don't think I would have had the skills to do this by hand.
It might be worth a look at how far that reed can move if given enough air.

There is only one upright block, with the other two laid flat.  There isn't another block for the reed to make contact with.
Logged
C#/D player

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Curious note rattle/pitch change
« Reply #6 on: March 18, 2019, 06:07:12 PM »

It could be making contact with the first fold of the bellows.  The first “fold” is a single layer and can be cut away.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Re: Curious note rattle/pitch change
« Reply #7 on: April 02, 2019, 05:11:55 AM »

I'm somewhat disappointed to admit that I was unable to track down the root cause of this problem!  I tried everything I could think of, but no luck. I can't for the life of me understand what it could have been...

Funny thing is, when I went to give the accordion back to the owner, brought his attention to this particular issue and explained all I had done, he told me that I should have asked him first because the issue never bothered him - he said he just considered it part of the "charm" of this old instrument!  Oh, well...
Logged
C#/D player
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal