Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Slow honking Hohner club basses  (Read 977 times)

0 Members and 1 Guest are viewing this topic.

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Slow honking Hohner club basses
« on: May 29, 2019, 10:17:57 AM »

On a few basses the really low reed is a bit slow to respond and then produces its wonderful deep honking bass. More than once I've thought I could hear someone walking upstairs when it's just the valve opening and closing.
Is this just a result of the inertia and mass of the weight soldered on, or can I improve the response?
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Slow honking Hohner club basses
« Reply #1 on: May 29, 2019, 12:55:25 PM »

You can check the response on a tuning table, if you have one, by removing the reed block and testing, experimenting with different rates of airflow. Big bass reeds sometimes need a surpringly big gap between the tip and the slot to work optimally. Also, if your valves are old and a bit stiff they might take longer to close which would also slow down reed response.

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Slow honking Hohner club basses
« Reply #2 on: May 29, 2019, 04:10:34 PM »

Yes I pulled the gap open a bit more and everything sounded better. I'm going to have to replace a couple of valves too. They certainly speak faster with the valves held shut.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Slow honking Hohner club basses
« Reply #3 on: June 01, 2019, 04:07:03 PM »

As a final check when I had the bottom end open I pulled off the curled valves and turned them over.
I realise this is an illegal move and only affects the push reeds but the difference between push and pull, especially on Bb, was remarkable.
New valves will arrive next week and I'll do it properly.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal