Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Repair to cracked bellows frame  (Read 1352 times)

0 Members and 1 Guest are viewing this topic.

Kon

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 165
Repair to cracked bellows frame
« on: July 20, 2019, 08:56:02 PM »

Hello,

I've had a bit of a look inside my GC Erica and have spotted a small crack to the bellows frame where one of the bellows pins sits. I guess it's probably not a huge issue, but not something I want to leave to deteriorate further.

I wanted to check how people would go about fixing it. My current best guess is to glue with PVA and then reinforce by gluing a strip of plywood over the top of the cracked section. Any thoughts? Suggestions on how best to clamp this would be welcome - do I clamp the whole bellows, or remove the frame and work on that only?

Thanks!
Logged
GC Erica

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Repair to cracked bellows frame
« Reply #1 on: July 20, 2019, 10:37:02 PM »

It doesn't look too serious.

Don't try removing the frame from the bellows - you would only create more problems for yourself.

PVA glue is a good option. Run some glue into the crack and work it in using a thin blade or a needle. Then simply clamp gently with a pincer-type spring clamp, or whatever you have available. It's OK to clamp over the last bellows fold - perhaps with a protective strip of wood.

Alternatively, use some cyano-acrylate 'superglue'. It has good penetrative properties and should wick itself into the crack. Either clamp it as above, or use finger pressure to hold the crack closed for a few seconds until the glue sets. Be careful not to glue your fingers to the frame!

Either method should work well and with no need to use a reinforcing strip of plywood on the inside.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Jon Stapleton

  • Member
  • *
  • Offline Offline
  • Posts: 44
Re: Repair to cracked bellows frame
« Reply #2 on: July 20, 2019, 11:08:24 PM »

What Steve said  that crack won't cause you problems even if you do nothing     glue and clamp :||:
Logged

Kon

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 165
Re: Repair to cracked bellows frame
« Reply #3 on: July 21, 2019, 10:29:05 AM »

Thanks Steve and Jon!

Good to hear, I will glue it up as you suggest and not worry about reinforcing it.
Logged
GC Erica

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repair to cracked bellows frame
« Reply #4 on: July 21, 2019, 10:40:22 AM »

Make sure you use a good quality glue designed for wood.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Kon

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 165
Re: Repair to cracked bellows frame
« Reply #5 on: July 21, 2019, 03:42:59 PM »

Ah Theo, I fear I may be in trouble with you now. I used cyanoacrylate as suggested by Steve, as it was what I had most easily to hand. It seems to have done a good job though!
Logged
GC Erica

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repair to cracked bellows frame
« Reply #6 on: July 21, 2019, 03:52:29 PM »

Cyano has the advantage as wicking to the full extent of thin cracks, though it's not quite as strong as a a good wood glue.  It should be fine.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Kon

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 165
Re: Repair to cracked bellows frame
« Reply #7 on: July 21, 2019, 03:59:23 PM »

Thanks for the reassurance Theo! I guess I'll find out in the long run whether it holds up but seems good for now, and I did think the wicking would be useful - would have been tricky to properly get PVA in there.
Logged
GC Erica

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Repair to cracked bellows frame
« Reply #8 on: July 26, 2019, 10:00:10 AM »

I'm a bit late to this, but looking at the photo it doesn't look like the crack is anywhere near the outside of the frame. It's a big splinter showing on the inside and top edge as you look at it.
It won't have any effect on the strength or airtightness so all you need to do is stop it getting worse. The fact that the pin runs through it means you can't really glue it back in place but cyanoacrylate or PVA or almost any wood adhesive other than PU will stop it getting worse.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Repair to cracked bellows frame
« Reply #9 on: July 26, 2019, 10:36:46 AM »

...The fact that the pin runs through it means you can't really glue it back in place but cyanoacrylate or PVA or almost any wood adhesive other than PU will stop it getting worse.
I don't really understand why you say it can't really be glued it back in place because the bellows pin runs through the crack. I've repaired a crack like this myself using cyanoacrylate glue. All that was necessary after the glue had set was to run a small undersized drill (held with fingers) through the hole to clear any excess glue which had oozed into the hole (which was hardly any).
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Repair to cracked bellows frame
« Reply #10 on: July 26, 2019, 01:29:09 PM »

In my experience when a splinter is formed from a fixing, whether predrilled or not, the splinter never lies quite back in place. The bruising of the timber by the hole will have slightly altered the grain direction preventing the fit.
A decent amount of PVA forming a bit of a blob over the offending area will prevent it getting worse, but the only way to get it back and looking as nature and Herr Hohner intended is to cramp it very tightly as the glue dries.
It would be impossible here, and frankly totally unnecessary to use cramps, and anyway if it hadn't been discovered it almost certainly wouldn't have mattered anyway.
And I'd have stuck a blob of fast drying PVA over the offending bit in less time than it took to type this.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repair to cracked bellows frame
« Reply #11 on: July 26, 2019, 02:53:39 PM »

I don’t see any reason why this repair could not be clamped, as any glued repair or joint should be. Just needs a clamp with a thin jaw that will slip between the frame and the first bellows fold from the inside of the belows.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal