Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1] 2   Go Down

Author Topic: Retaping Bellows...Again  (Read 3259 times)

0 Members and 1 Guest are viewing this topic.

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Retaping Bellows...Again
« on: August 11, 2019, 12:15:39 PM »

Ok...after countless viewings of Lester's video and weeks of procrastination I've taken the bellows off my pressedwood with a view to retaping.

The current tape isn't your standard gold but a matt black...(the bellows are green...) and it seems rather reluctant to part company with the bellows. I'm reluctant to use too much brute force (combined with rather a lot of ignorance...) as I don't want to damage the bellows themselves.
Might gentle dampening help in this case or am I being over cautious?

Concerned of Mobberley.
Logged
On the edge of Cheshire's Golden Triangle, apparently...

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Retaping Bellows...Again
« Reply #1 on: August 11, 2019, 01:45:21 PM »

Gentle dampening is OK. Use a damped sponge or cloth to moisten the bellows tape. Work on a single fold at a time. Leave for a couple of minutes after dampening and then try to carefully peel and lift off the old tape using a blunt knife or scraper. With luck you should be able to remove a long-ish section of tape. Re-dampen as needed, but take care not to saturate the bellows fold.

It's a horrible messy job and needs a lot of patience. Good luck!
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Retaping Bellows...Again
« Reply #2 on: August 11, 2019, 04:51:12 PM »

I'm more adventurous than Steve!  I spray the bellows with a fine mist sprayer and do a whole side at a time.  If you hold the bellows by one end so it hangs down with the fold slightly open it is possible to control where most of the spray lands.   Do it from both sides, then close the bellows, put it in a plastic bag and leave for 20 minutes.  If the tape doesn't come off easily repair the spray and wait.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Retaping Bellows...Again
« Reply #3 on: August 11, 2019, 11:38:53 PM »

Theo, you terrify people!
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Nick Collis Bird

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3785
  • Been squeezing melodeons for over 48 years (badly)
Re: Retaping Bellows...Again
« Reply #4 on: August 12, 2019, 07:20:51 AM »

Agree with Steve and Theo. Even if you over spray Baz if won’t do any damage.
  Let’s just hope that if it had been retaped  before, that person used water soluble adhesive . 🙏
Logged
Has anyone heard of the song. “ Broken Alarm-clock Blues” ? It starts   â€œI woke up this Afternoon”

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: Retaping Bellows...Again
« Reply #5 on: August 12, 2019, 07:22:46 AM »

I'm more adventurous than Steve!  I spray the bellows with a fine mist sprayer and do a whole side at a time.  If you hold the bellows by one end so it hangs down with the fold slightly open it is possible to control where most of the spray lands.   Do it from both sides, then close the bellows, put it in a plastic bag and leave for 20 minutes.  If the tape doesn't come off easily repair the spray and wait.

Fine mist sprayer.....like a greenhouse/houseplant mist sprayer running on pure unadulterated Adam's Ale?
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Retaping Bellows...Again
« Reply #6 on: August 12, 2019, 08:52:13 AM »

The one I use is a repurposed cosmetic bottle of some kind,  but any kind of spray bottle will do.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Re: Retaping Bellows...Again
« Reply #7 on: August 12, 2019, 09:07:54 AM »

Thanks all...I've managed to do 4 folds so I'm at the point of no return... >:E
Logged
On the edge of Cheshire's Golden Triangle, apparently...

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Retaping Bellows...Again
« Reply #8 on: August 12, 2019, 10:31:15 AM »

Thanks all...I've managed to do 4 folds so I'm at the point of no return... >:E
My thoughts are with you at this difficult time

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Re: Retaping Bellows...Again
« Reply #9 on: August 12, 2019, 11:23:16 AM »

Thanks all...I've managed to do 4 folds so I'm at the point of no return... >:E
My thoughts are with you at this difficult time
Should anyone be thinking of undertaking this task, your Granny's old butter knife will prove invaluable. (Other elderly female residents may be available...or indeed male....) :|glug
Logged
On the edge of Cheshire's Golden Triangle, apparently...

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Retaping Bellows...Again
« Reply #10 on: August 12, 2019, 11:28:16 AM »

Thanks all...I've managed to do 4 folds so I'm at the point of no return... >:E
My thoughts are with you at this difficult time
Should anyone be thinking of undertaking this task, your Granny's old butter knife will prove invaluable.
Snap! Bingo! (etc.) That's exactly what I use!
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Re: Retaping Bellows...Again
« Reply #11 on: August 12, 2019, 01:30:44 PM »


  Let’s just hope that if it had been retaped  before, that person used water soluble adhesive . 🙏

Seem to have done...comes o4f in two layers...the black top leaving behind the white was sticky bit... :|glug
Logged
On the edge of Cheshire's Golden Triangle, apparently...

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Re: Retaping Bellows...Again
« Reply #12 on: August 12, 2019, 04:14:31 PM »

Should anyone be thinking of undertaking this task, your Granny's old butter knife will prove invaluable.
Snap! Bingo! (etc.) That's exactly what I use!
"Warranted Sheffield Manufacture" I trust? :|glug
Logged
On the edge of Cheshire's Golden Triangle, apparently...

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Retaping Bellows...Again
« Reply #13 on: August 12, 2019, 06:39:58 PM »

Should anyone be thinking of undertaking this task, your Granny's old butter knife will prove invaluable.
Snap! Bingo! (etc.) That's exactly what I use!
"Warranted Sheffield Manufacture" I trust? :|glug
Of course!
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: Retaping Bellows...Again
« Reply #14 on: April 11, 2020, 10:12:57 PM »

Advice needed (before I try this on a set of bellows that matter) ::):

A couple of my acquisitions absolutely need at least some of the bellows tapes replaced. Not a job I've done before.

A search for a fine mist sprayer ended with the realisation that the choice available to me is a 20 litre backpack model last used for spraying thistles or an old windolene bottle.

I have tried a wall paper steamer instead- experimenting on a section of scrapped PA bellows.  The steaming pipe is a piece of 20mm toilet overflow pipe with a quarter section cut out of it that saddles over one fold at a time

The tapes in question appear to be fabric based, attached with a hot glue. 30 seconds of steam then start peeling. When the tape starts resisting repeat steaming. Or maybe go onto the next fold to avoid soaking damage to the underlying bellows paper? First two folds shown after stripping...one of them part of the bellows paper has failed before the glue did.

Is the damage to the bellows paper in the normal range for the tape stripping operation or is the method just too viscious for this job?




« Last Edit: April 11, 2020, 10:19:38 PM by Peadar »
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Retaping Bellows...Again
« Reply #15 on: April 11, 2020, 10:27:33 PM »

Looks good to me.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: Retaping Bellows...Again
« Reply #16 on: April 11, 2020, 10:51:57 PM »

Looks good to me.
Thanks Theo. Not perfect but I'll practice on the other folds/sides before I go for the real thing.
Logged

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Re: Retaping Bellows...Again
« Reply #17 on: April 12, 2020, 01:43:10 AM »

I use Theo’s method and it has worked every time.
Logged
C#/D player

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Retaping Bellows...Again
« Reply #18 on: April 12, 2020, 09:15:44 AM »

With older boxes like your Club you can often pull off the tape without any need for steam or water spray.  If you can see a corner that is not firmly glued try lifting it and pulling.  If that does work it much less messy.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Julian S

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1628
  • D/G Pastourelle 2, Dony, Pokerwork, G/C Pariselle
Re: Retaping Bellows...Again
« Reply #19 on: April 12, 2020, 10:07:22 AM »

I'm pleased that I've got some tape somewhere for essential repairs - and I think that this is a good time to find it and get the bellows in order for whenever we are let out again.
(I can probably guarantee that I haven't quite enough tape or adhesive for all the repairs - such is life !)
Certainly my experience has been that old tape can be quite easy to take off without damping it - probably shouldn't say that because I'll now find the next repair much more problematic. And the old favourite round ended butter knife has proved very useful both in helping remove tape and apply glue (though I advise careful cleaning before returning to the kitchen drawer ! ::))

J
Logged
Old Bones Dance Band
Pages: [1] 2   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal