Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Tuning woes: inconsistent (varying) tuner readings  (Read 1057 times)

0 Members and 1 Guest are viewing this topic.

fc diato

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 146
Tuning woes: inconsistent (varying) tuner readings
« on: September 22, 2019, 09:05:27 PM »

Here's a different type of tuning discrepancy:

I have been learning to tune this summer, finally circling a real box (an old Saltarelle Bouebe) after reading everything I could find, making & buying the tools, and then practicing on a small junk box. 
My problem is that I cannot get out of the starter’s block because I can’t get consistent tuner readings.  (I am using Peterson’s on a laptop; Zoom as microphone; testing with blocks in the box; one side taped to get single note; I have already fixed leaks, and flattened the bottom plate of the blocks that were ever so slightly warped).
There are two different issues:

1) Some notes want to never give the same reading. Different readings within a few minutes can range by +/- 2 cents.  I know loudness affects readings, but I try controlling, and on most notes it’s fine. Oh, and I've tested with a box that was professionally and expertly tuned this summer, and do not have the problem.  Some notes (always the same ones) are just not cooperating.
Even worse are notes that do not stabilise ever … the readings cycle around full speed in a 1-2 cent range.  The worst are on two plates on the low end (all 4 notes wonky).  I've tried different microphone placements, but that's not it.

So I’m surmising that there’s another issue there that I need to fix before even thinking of taking file or scraper to metal.  Could it be iffy wax?  It’s 20+ years old, but the box has lived in Canada where humidity levels cycle from bone dry to dripping wet (20% to 95%). The wax on the base side was cracked and dry, and I rewaxed that.  The wax on the treble side looks fine; seems still tacky and no cracks that I can detect no matter how closely I look.  I also tried holding the plate (on tuning table) while sounding one of the bad notes, but it makes no difference.  Can wax go off even if it does not seem so?  Could that be a likely culprit? (Asking because I hate waxing and am not particularly good at it yet.)

If not wax, any ideas about what I could check … ?

2) Readings that vary for the whole box over time.  I wonder if that’s weather related.  I first started in mid-August when it was 30+ degrees and 90% humidity, noting down all my readings.  Discouraged by the wonky stuff (point 1) I stopped.  Now, one month later, at 20 degrees and 50% humidity I’m back at it, and almost all readings are lower (range from .5 to 2). 
Am I right to think such variation is due to weather?  (Wondering what will happen in winter at 20% humidity…. Argh!)  Does anybody know if variations are linear ?  In other words, if I tune now, I’ll be at an average out-of-tunedness for summer and winter, but not horribly so for either?

Sorry to go on so long, but I'm puzzled, frustrated ....and ignorant.
Logged
fc diato

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tuning woes: inconsistent (varying) tuner readings
« Reply #1 on: September 22, 2019, 10:33:21 PM »

To answer a part of your questions:
1)  wax that looks ok can be failing. If you have a reed that will not stabilise in pitch try pressing on the reed plate with a small screwdriver while you sound the reed. If that fixes the problem then the wax is no longer holding the reed plate securely.

2) valves that are not operating correctly.  Old leather valves can become stiff and not open fully, they can be curved and close late, valve in the underside may make contact with the wood of the reed chamber so it is slow to open and close. 

3) there can be very slight contact between the reed tongue and the reed plate.  This can be caused by many things - rust on the edge of the reed tongue, damage to the edge of the vent, burr on the edge of the tongue from filing, other contamination such as wax, glue that has spread from the valve to the edge of the reed tongue, reed tongue that is slightly off centre.

I can’t help with the temperature problem,  I usually complete  a full tuning over a few days,  and here in the UK temperature is less varied, so I’ve not found this to be a problem,  though I know temperature does affect reed pitch.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Tuning woes: inconsistent (varying) tuner readings
« Reply #2 on: September 23, 2019, 12:48:16 AM »

I concur with Theo's diagnoses.

My recommendation for the unstable notes on the lowest pair of reed plates would be to replace the valves as a matter of course, even if they look OK. This will involve removing the reed plates in order to replace the inside valves, and then re-waxing. So then you will have new valves and new wax. That should hopefully solve your pitch instability problems which, if that is indeed the answer, should point towards a solution for other unstable notes in the rest of the instrument.

There is one other possible cause of unstable pitch: the reed tongue being not firmly held by the rivet. Once again, it may seem OK, but if all else fails, it is worth removing the reed plate and gently hammering the rivet head, while supporting the underside of the rivet on a small anvil or similar steel block (a hefty hammer head will do). This is a very rare problem; I've only ever known it occur twice in over ten years of working on reeds.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Re: Tuning woes: inconsistent (varying) tuner readings
« Reply #3 on: September 23, 2019, 01:06:27 AM »

There is one other possible cause of unstable pitch: the reed tongue being not firmly held by the rivet. Once again, it may seem OK, but if all else fails, it is worth removing the reed plate and gently hammering the rivet head, while supporting the underside of the rivet on a small anvil or similar steel block (a hefty hammer head will do). This is a very rare problem; I've only ever known it occur twice in over ten years of working on reeds.

I’m surprised to hear that. From my limited experience, I’ve come across this problem quite a few times. Hammering the rivet as you have described (or putting it in a vice) was a solution the problem in each case. There was one instrument that I worked on that had this problem on about half the reeds!
« Last Edit: September 23, 2019, 01:08:02 AM by mselic »
Logged
C#/D player

fc diato

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 146
Re: Tuning woes: inconsistent (varying) tuner readings
« Reply #4 on: September 23, 2019, 12:51:20 PM »

Thank you!  I wrongly thought if valves looked and behaved OK (the visible ones), no rust, passed the ‘press the reed plate test’… I had done my diagnosis.  Clearly not. 

So off with the wax.  Alas. I guess I should be happy at an opportunity to practice waxing (but long-live screwed on reeds!).

Mselic:  If memory serves, you live not far from me and so deal with the same wild temperature-humidity swings.  Have you noticed if or how it affects tuning? 
Logged
fc diato

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Re: Tuning woes: inconsistent (varying) tuner readings
« Reply #5 on: September 23, 2019, 02:42:55 PM »

Mselic:  If memory serves, you live not far from me and so deal with the same wild temperature-humidity swings.  Have you noticed if or how it affects tuning? 


I’ve not noticed humidity affecting the tuning.
Logged
C#/D player
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal