Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 2 3 [4]   Go Down

Author Topic: Pokerwork clacking  (Read 16089 times)

0 Members and 1 Guest are viewing this topic.

Martyn

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 455
  • Hohnerohner
    • Martyn White Melodeon Tuning and Repairs
Re: Pokerwork clacking
« Reply #60 on: January 07, 2010, 03:16:15 PM »

 I don't want to damage the box itself and was thinking about gluing the piece in place but I realize that would make it difficult to remove the piece afterward, if it was necessary.





A strip of double sided tape should do the job and is easily removed if need be.

Martyn
Logged
'Anything from a small repair to a full restoration'.
www.melodeonrepairs.co.uk

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Pokerwork clacking
« Reply #61 on: January 07, 2010, 04:33:43 PM »

Screws do allow the strip to be removed easily for adjustments.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

dee.robot

  • New Starter
  • Offline Offline
  • Posts: 2
Re: Pokerwork clacking
« Reply #62 on: April 16, 2014, 08:25:12 AM »

Hi. Have been reading this thread as I am trying to upgrade my pokerwork 4 stop one row. It has the nasty plastic keyboard and  I'm checking that the principle for reducing the travel of the buttons is the same as for the 2 row. And wondered where I can find the photos Theo spoke of. Any help much appreciated.
Regards
Dee
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Pokerwork clacking
« Reply #63 on: April 16, 2014, 08:30:53 AM »

No, the same method of limiting key travel can't be used on a 114 because the case does not form a lip behind the levers as it does on a pokerwork or Erica.
Limiting the key travel does not in itself reduce noise, to do that you could try re-facing the pallets. It can also help a lot to carefully centralise the buttons on the keyboard holes.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: 1 2 3 [4]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal