Here's what I found to be the best solution (by far).
There's a very good temp-controlled soldering Iron called "A-BF GS90D". If you shop around, you can get one for under £30 delivered. Well-made and works like a dream for soldering - if only I had something like this in my teenage years

Note: If you get it with a non-UK plug you're advised to cut it off and install a UK one instead of using a plug adapter. The adapters tend to spark and this sparking will fry your temp control chip in no time.
For actual soldering I use solid brass tips instead of the fancy never-works-right plated long-life ones that it comes with.
But for waxing you can take the wider long-life bit, drill a hole in it and bolt on a wee brass plate. Has to be a bolt-on design to be able to install it.
Set the temp to, say, about 100 degrees or whatever works for you, and Bob's your uncle. You can use the "spoon" to do single wax-in wax-outs, or you can scoop-melt some wax onto the hot spoon right off the hard block and then feed it onto the reedblock.




<a target='_blank' href='
https://imgbb.com/'>imagehosting[/url]