Ugh. I hate trying my own repair, but this seems like it SHOULD be easy. Filled with anxiety. Looking for advice.
On my Baffetti 3-row (MM), a single reed has stopped sounding. So you're going along MM until for the briefest of moments you are just M -- and it really stands out. Happened suddenly. No apparent cause (like, I didn't drop the box or anything).
What would you all suggest?
Almost certainly this is caused by a bit of dust or fluff caught between the reed tongue and the slot.
Sometimes this can be cured by sharply pushing and pulling the bellows in and out while holding down the relevant button. But often this does not work. Nevertheless, the remedy is simple - you just need to pull the bellows pins, open up the box and give the correct reed tongue a bit of a twang, using a thin pen-knife blade, feeler-gauge or similar. That will nearly always clear the debris.
The possible problems you might encounter are (a) identifying which reed is blocked - the debris may not be easily visible, and (b) accessing the problem reed if it is a pull reed, as it will be on the underside of the reed plate.
If it is a push reed, usually you can count the reed plates along corresponding to the button number. Not always foolproof, because sometimes the reeds of one row are mounted on the reed block of the opposite row. But you should be able to identify the reed by twanging them gently and listening to the pitch. Also each button will operate two reeds, the M and the M tremolo. Just twang them both and all should be well.
If it is a pull reed causing the problem, the reed tongue will be hidden from view under the valve. In this case proceed as above but use a cocktail stick to gently lift the valve and push the stick down through the slot until you can feel the springiness of the reed tongue. Just ease it up and down a few times and that should clear the blockage. To identify which reed to work on, you can find the corresponding push reed; the problematical pull reed will be on the underside of that particular reed plate.
Like changing a fuse or lightbulb, it's an easy enough fix that nearly everyone has to do at some stage. Just go gently and you will be alright.