USB often defaults to Stereo, so to change to Mono use the recording panel as below, and change Stereo to Mono.
"Audacity by default should already be set to record in stereo. If this is not the case, use Device Toolbar to select the playback and recording devices and to set the channels to "2 (stereo) Recording Channels".
Alternatively you can open the Audacity Preferences, choose the \xe2\x80\x9cDevices\xe2\x80\x9d section on the left, then in the "Recording" panel, change the number of recording channels to "2 (Stereo)". {{note|Windows: Many USB recording devices, even if stereo, are seen as "microphones" so set by Windows to record in mono. If Audacity is set to record in stereo this will cause both channels to have the same content as one of the channels. To set Windows to record the device in stereo:
By the system clock, right-click over the Speaker icon select Sounds then the Recording tab, and then click on the USB device in the list and click Properties. Click the Advanced tab set your required bit rate and sample rate from the Default Format dropdown (normally "2 channel 16-bit 44100 Hz")."