Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Some 'practical' Chord/Bass octave apart advice  (Read 722 times)

0 Members and 1 Guest are viewing this topic.

Nigel.H

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 586
Some 'practical' Chord/Bass octave apart advice
« on: April 16, 2021, 11:48:48 AM »

I have started fettling the Bass & chord side of the Viktoria project.

I have the Bass block sorted, barring a little reduction via "baffle" insertion for the Bass plate height and 'expansion' of the #2 plate there were no issues.

The set up of the Victoria is - as most fettler's will probably know - to play "two" chord plates with the x2 Bass reed plates, so it is a x4 reed Bass......and x4 reed chord with the relevant chord note played an octave apart, ie. 3/4 plate with a 4/5 plate......4/4 plate with a 5/5.

The Bass blocks are 1's,2's & 3's correspondingly on their pair of plates.


I am currently looking to fit it out as it stands, ie. typical 8 button layout, for now.  I am going to fit it without 1/3rds, but still looking to fill the voids on the blocks so 'doubling' up on the plates for the chords to give x4 voices on the i & v.

My issue is that - for the new F/Bb set up, I don't really have the "higher" octave plates to correspond to the higher paired plates as per the Viktoria layout.  I do have the plates to outfit it not " an octave up", ie. Bb3 / F4.....with another Bb3 / F4........rather than a Bb4 / F5  and a F4 / C4 with a F4 / C4 rather than a F5 / C5.

Am I going to be losing / gaining......messing up ? by going without the octave change on the #2 plate ?  On the Bass button, it will play both 'unison' plates? and both Bass plates.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Some 'practical' Chord/Bass octave apart advice
« Reply #1 on: April 16, 2021, 11:57:06 AM »

It will still work, but you will loose a little brightness in the sound from the highest reed.  In this situation I have often used a treble reed plate of the correct pitch.  The reed chamber has to be partially blocked for the shorter plate, but it is an effective solution if you like to maintain the bright sound.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Some 'practical' Chord/Bass octave apart advice
« Reply #2 on: April 16, 2021, 12:07:07 PM »

That is exactly where I am with my G/C/Acc conversion.
I have done the bass pairs and have rough tuned the chord reeds. I ended up doing almost exactly what Theo suggest and I've weighted down the nearest available spare
treble plates.
Like yours, it will be a full sounding bass end. I'm not putting any stops in though. It will be either full on or full off.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

Nigel.H

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 586
Re: Some 'practical' Chord/Bass octave apart advice
« Reply #3 on: April 16, 2021, 03:21:03 PM »

Sound advice......as always.....thanks both.

By virtue of the donor Box being in Bb/Eb, I had a couple of the 'mis-match' chord reeds I needed in the Hohner set in the higher range, as fitted when it came for the Bb pair.  I have converted others from elsewhere in various other sets to double up on the two I didn't and the 'v' pairs.

I may 'soft-fit' the reed block reduction in case it sounds wrong.......I don't think it will, the bulk of the reeds in play are the Castagnari ones with just the high ones from Hohner donor's.  If it isn't right, I am sure there are enough unison reeds from the 18 bass set to fill in, albeit in the same octave. 

I am not putting any Stops in - not for now......just leaving the 1/3rds out altogether.  I may increase it to 12 bass if I grow more fingers   ::) ......learning to use the '8' ( or even half of them! ) will do for now :-[. 

I did leave the Clubbed pair of Eb/G instead of converting to Eb/Eb though, just for now.  If I make it sound "wrong" ( or more wrong than usual ) I will alter it, but a cursory bimble around the Basses last night, without the extra plates, sounded ok as did another run this a/m with the 'big' chord plates in place.   

++++++++++

All sorted for now, not easy as the gap between some 'pairs' on the plate is a bit of a stretch from the norm.   The 'high side' of the bank is messy to look at - the plates are tight to get in. I had three of the old Hohner 'long plate'/high pitch reeds, the rest are "small' and probably have a different tone, especially as the chambers have had to be substantially "shrunk".  Hopefully it gets 'blended' ("lost" ::) ) in the overall effect which my inexpert independent assessor says it's 'ok' so I'll be allowed to play it in the house.
« Last Edit: April 16, 2021, 07:56:21 PM by Nigel.H »
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal