Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Hohner 1040 tuning etc  (Read 1443 times)

0 Members and 1 Guest are viewing this topic.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Hohner 1040 tuning etc
« Reply #20 on: March 15, 2022, 08:07:30 PM »

Ok. I think I need a scraper with the last 1 1/2 inches or so at a right angle so I can kind of scrape along the reed from above? Also, an Italian style lifter for when I need to raise the pitch of an inside reed (I don't like the Look of how the german ones work - ouch! ). I think I could possibly make that. Anything else?..

You can make a scraper like that from an old needle file.  Heat the part of the file to be bent to cherry red and allow it to cool slowly to anneal the steel. Reshape the file to a round section and square off the end.  Then bend as required.  It's safer to heat it again and bend while red hot.  Reheat to Cherry red and quench in water to harden
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Hohner 1040 tuning etc
« Reply #21 on: March 15, 2022, 09:53:07 PM »

Great advice as usual thanks. I just need some time now!..
Logged
Dancing about architecture since 1997
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal