Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Replacing corner diamonds  (Read 395 times)

0 Members and 1 Guest are viewing this topic.

Martyn Hunter-Wyatt

  • Member
  • *
  • Offline Offline
  • Posts: 16
Replacing corner diamonds
« on: October 17, 2022, 08:48:29 PM »

Is there a video on how to replace corner diamonds? I’ve done one but it turned out to be a mission. It will be satisfactory but I think it could be better. I found it very difficult to get the folds in the leather to form where I wanted them. Any tips from someone with more experience would be most welcome.
I saw a comment from Theo about replacing bellows if there were a lot of holes, but I only have the odd one or two to do.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Replacing corner diamonds
« Reply #1 on: October 17, 2022, 10:36:02 PM »

Much easier to patch the damaged gussets from the inside.  You need very thin leather, and the result is always a bit less flexible than the original.  Replacing the whole diamond from the outside does involve peeling back the edging tape and the lining paper and when I’ve tried that I’ve never been happy with the look of it.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Martyn Hunter-Wyatt

  • Member
  • *
  • Offline Offline
  • Posts: 16
Re: Replacing corner diamonds
« Reply #2 on: October 18, 2022, 09:00:43 AM »

Thanks Theo, I’ll try the next one from the inside.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal