Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1] 2   Go Down

Author Topic: Where's the Leak?  (Read 2628 times)

0 Members and 1 Guest are viewing this topic.

Pat McInnis

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 390
Where's the Leak?
« on: April 04, 2023, 04:06:19 AM »

I have an older set of Pokerwork bellows that are nicely retaped, and can't see any light through the corners if I shine a flashlight through. New foam gaskets and everything seems to fit snug but I can feel a whisp of air from all four corners of the treble side as if there is a gasket leak. I'm at a loss.
Logged

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Where's the Leak?
« Reply #1 on: April 04, 2023, 07:41:25 AM »

Check that the bellows are properly glued to the frame at the corners. If the retape included the fold up against the frame the bellows sometimes get pulled away from the frame (to get the tape in). Use wood glue to fix (wipe away residue with damp cloth).

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Where's the Leak?
« Reply #2 on: April 04, 2023, 07:51:17 AM »

A common mistake when fitting new bellows gasket is to curve the material at the corners so it Is further from the outer edge.  This can leave a gap right in the corner whe the end is in place.  It could also be lack of glue. To tell them apart carefully place a piece of masking tape round the outside of the corner so it covers the join between bellows and frame, but does not cover the gasket gap.  If you can still feel the leak it’s the gasket.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

folkloristmark

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 582
    • street entertainers
Re: Where's the Leak?
« Reply #3 on: April 04, 2023, 08:03:09 AM »

check the wood corners of the box and bellows as well air can find a route to the corners througth the wood joints. You can dust areas with a little talk powder.Baby powder to see were the air pufs up. Outside maybe.But are you sure the gasket is good.Can be sneaky these boxes
Logged
Mark Taylor
Folkloristmark

rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5055
  • Windjammer
    • Wesson Accordions
Re: Where's the Leak?
« Reply #4 on: April 04, 2023, 08:15:05 AM »

Remember how we used to find a puncture in a bicycle inner tube by immersing in a bucket of water .......... don't do that
Logged
Rees Wesson (accordion builder and mechanic)
Gungrog, Welshpool, Wales, UK
www.melodeons.com

george garside

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5401
Re: Where's the Leak?
« Reply #5 on: April 04, 2023, 10:51:03 AM »

the best part of ones anatomy to use to check for bellows leeks is ones cheek!  (OF FACE NOT ARSE!) it is the most sensitive bit of ones anatomy

george
Logged
author of DG tutor book "DG Melodeon a Crash Course for Beginners".

Pat McInnis

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 390
Re: Where's the Leak?
« Reply #6 on: April 04, 2023, 03:32:06 PM »

Remember how we used to find a puncture in a bicycle inner tube by immersing in a bucket of water .......... don't do that

Haha, I just pictured myself in scuba gear down at the local pool with a lineup of security guards waiting for me to re emerge.
Seriously though, good tips. Isolating the problem is the first step I think. Theo's suggestion of carefully taping the outer folds will be my first step. It's a shame there's nothing obvious but the fact that it's all four corners makes me suspicious of frame to bellows. I have also tried these bellows in a few boxes with the same result to eliminate an out of square box frame if that's even a thing.

Thanks gang
Logged

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Where's the Leak?
« Reply #7 on: April 04, 2023, 03:43:37 PM »

I got a cheap stethoscope from eBay and removed the diaphragm thing, so it’s just a tube on one end. Works v well for detecting exact location of a leak.

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Where's the Leak?
« Reply #8 on: April 04, 2023, 04:08:14 PM »

Replacing bellows gaskets was one of the first jobs I did when I started clarting about with melodeons. As I was bending the self-adhesive stuff around the corners, I became aware that I was stretching it a bit at the same time as bending. Although the actual height of the gasket didn't seem to have noticeably changed, I think that the density of the neoprene foam may have been reduced; therefore not giving the same sealing effect as the rest of it, under the same compression.
Maybe you could check that?
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Pat McInnis

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 390
Re: Where's the Leak?
« Reply #9 on: April 12, 2023, 08:58:03 PM »

OK I may be fighting a losing battle here. I did a light soap water spray around the bellows seem and saw bubbles in many places. mostly the corners but also right in the middle of the long side in a couple of places. Mostly through the gasket and a couple frame to bellows leaks. What a mess!! I just did a quick bit of measuring with the bellows frame compared to the box opening and was really surprised (I know I shouldn't be at this stage) at the huge run out. Up to 1/16" or even slightly more in spots. This seems like a terrible fit and the runout is on the box and the bellows frame. I assume that a tight frame fit would be pretty important for a starting point in achieving tight bellows.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Where's the Leak?
« Reply #10 on: April 12, 2023, 09:58:11 PM »

They do sometimes get distorted on old instruments.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Where's the Leak?
« Reply #11 on: April 12, 2023, 11:48:27 PM »

Coincidentally, just this evening; I've realised that the (really bashed about with celluloid separating etc.) body of the Busilacchio 1 row that I'm restoring is so misshapen that along the long sides only just contact the very edge of the gasket!
Pinching a possible cure from our Dear Leader, I might glue a strong bit of something on the inside, in an attempt to straighten them out and keep them stable. 
Fingers crossed, of course!
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

tirpous

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1403
Re: Where's the Leak?
« Reply #12 on: April 13, 2023, 02:01:02 AM »

Quote
Fingers crossed, of course!

I guess you're all set for cross-row playing, then ?  ;)
Logged

Pat McInnis

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 390
Re: Where's the Leak?
« Reply #13 on: April 13, 2023, 02:10:40 AM »

Quote
Fingers crossed, of course!

I guess you're all set for cross-row playing, then ?  ;)

Cross row playing on a one row...This I gotta see.
Logged

tirpous

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1403
Re: Where's the Leak?
« Reply #14 on: April 13, 2023, 03:13:51 AM »

Quote
Cross row playing on a one row...This I gotta see.

Advanced melodeon techniques !  ;D
Logged

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Where's the Leak?
« Reply #15 on: April 13, 2023, 08:19:32 AM »

"I guess you're all set for cross-row playing, then ?"

Give over, changing bellows direction is just about all the exercise I get!
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Peter Cane

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 204
Re: Where's the Leak?
« Reply #16 on: May 01, 2023, 07:32:55 PM »

A common mistake when fitting new bellows gasket is to curve the material at the corners so it Is further from the outer edge.  This can leave a gap right in the corner whe the end is in place.  It could also be lack of glue. To tell them apart carefully place a piece of masking tape round the outside of the corner so it covers the join between bellows and frame, but does not cover the gasket gap.  If you can still feel the leak it’s the gasket.
The bellows gaskets on most of my boxes are curved around the corners.
How exactly do we fit them properly please?
Logged

Peter Cane

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 204
Re: Where's the Leak?
« Reply #17 on: May 12, 2023, 10:52:18 PM »

Okay I am about to replace the leather strip bellows gasket on a Hohner Liliput. It still had the original gasket on circa 80 years old and it was glued on and curved around the corners.
I read on this topic that this is a common mistake.
I find it a bit baffling that Hohner repeatedly makes this mistake.
I have asked here what the correct method should be but we are all busy and no answers yet.
If the gasket must not be bent around then it must be cut at 45 degree angles at the corners.
So I guess I will try that and see what happenz.
Unless of course......
You know differently,?
Logged

fc diato

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 146
Re: Where's the Leak?
« Reply #18 on: May 12, 2023, 11:09:31 PM »

Re the corners with bellows gasket:  what I learned - you can cut just a notch into the width, so that when you make the corner everything touches, but no overlap or bunching. Works well in my experience.
Logged
fc diato

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Where's the Leak?
« Reply #19 on: May 12, 2023, 11:46:24 PM »

Try to fit the gasket so that it takes the same curve of the outside edge of the bellows frame, but set in from the edges.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1] 2   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal