Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Rejuvenating an old Pokerwork grill  (Read 2655 times)

0 Members and 1 Guest are viewing this topic.

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Rejuvenating an old Pokerwork grill
« on: April 06, 2023, 05:31:32 PM »

Hi there! So, on the one hand I have a 1040, all shiny metal bits but no grill, and on the other I have a grill from a doner box, which is all dulled from various attempts to remove rust. Having removed the rust, how do I now make the grill all shiny and new again? I gather I need some kind of primer and perhaps some chrome spray or something, but I’m fairly clueless, so any advice and links to products (budget if possible) would be appreciated!.. thanks
Logged
Dancing about architecture since 1997

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Rejuvenating an old Pokerwork grill
« Reply #1 on: April 06, 2023, 06:22:04 PM »

In my experience, and not just with melodeons, so called "chrome" spray or paint is just not! Some spray filler/primer and a colour of your choice would be far better.
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Rejuvenating an old Pokerwork grill
« Reply #2 on: April 06, 2023, 06:38:20 PM »

I cleaned up the grille of a Modell II with a Dremel and the tiny little sanding disks. It looks good enough not to need any paint.

george garside

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5401
Re: Rejuvenating an old Pokerwork grill
« Reply #3 on: April 06, 2023, 06:39:54 PM »

a gloss black aerosol respray would look nicer than  any attempt to  a paint substitue for chrome. New grilles are available, I think, from CMG music (see website)
george
Logged
author of DG tutor book "DG Melodeon a Crash Course for Beginners".

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Rejuvenating an old Pokerwork grill
« Reply #4 on: April 06, 2023, 07:43:47 PM »

Repaint is easy as long as you prepare.  The grill should be spotlessly clean and free of rust, grease, fingermarks etc. A god scrub in hot soapy water will do the job.    Remove any rust from the back as well and treat it with a rust stabilising chemical. 
Spray with a metal primer, a couple of coats then spray with your chosen colour, three or four coats.  allow to dry between coats. A larger cardboard box makes a good spray booth.  The paints sold for car body repair are what I use.

Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Rejuvenating an old Pokerwork grill
« Reply #5 on: April 06, 2023, 10:45:30 PM »

Some great tips, thanks! I’ll see what I can manage to cobble together armed with that information…
Logged
Dancing about architecture since 1997

Tone Dumb Greg

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4955
    • Dartmoor Border Morris
Re: Rejuvenating an old Pokerwork grill
« Reply #6 on: April 06, 2023, 10:54:57 PM »

My 1040's grill is a matt aluminium colour. I'm not sure if it's original. Theo may know. The person I bought it off said he sold it to him.

Point is, it looks OK. Not too brash, but more apt than black.
Logged
Greg Smith
DG/GC Pokerwork, DG 2.4 Saltarelle, pre-war CF Hohner, Hohner 1040 Vienna style, old  BbEb Hohner that needs a lot of work.

ACCORDION, n. An instrument in harmony with the sentiments of an assassin. Ambrose Bierce

Nick Collis Bird

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3785
  • Been squeezing melodeons for over 48 years (badly)
Re: Rejuvenating an old Pokerwork grill
« Reply #7 on: April 07, 2023, 06:21:14 AM »

Another alternative is to get it re-Chromed from a firm like Lathco in Sheffield. It’s not that expensive.
Logged
Has anyone heard of the song. “ Broken Alarm-clock Blues” ? It starts   â€œI woke up this Afternoon”

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Rejuvenating an old Pokerwork grill
« Reply #8 on: April 07, 2023, 08:18:48 AM »

But not chrome, originally they were bright nickel plate.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

John Burks

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 142
Re: Rejuvenating an old Pokerwork grill
« Reply #9 on: April 07, 2023, 09:01:41 AM »

Just finished yesterday. 

I wire brushed then used:

Grey Etch Primer (better bond) Leave for 24 hours 2 coats
BMW Titan Titanium 2 Coats
Hycote clear lacquer 2 Coats

All from Halfords

Then red speaker material.

Here are a couple of photos. Hope this helps  (:)

John
« Last Edit: April 07, 2023, 09:05:47 AM by John Burks »
Logged
Francois Dedenis D/G, Koch Overture G/C , Custom "Picoletta" D/G, Hohner Modell 1 B/C, M Hohner 5A B/E (Phosphor Bronze)

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: Rejuvenating an old Pokerwork grill
« Reply #10 on: April 07, 2023, 09:52:23 AM »

Looks lovely.
Logged

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Re: Rejuvenating an old Pokerwork grill
« Reply #11 on: April 07, 2023, 10:31:44 AM »

Were I from Devon I'd say proper job.
As a Black Country lad, you'll have to make do with bostin'  :|glug
Logged
On the edge of Cheshire's Golden Triangle, apparently...

Thrupenny Bit

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7232
  • happily squeezing away in Devon
Re: Rejuvenating an old Pokerwork grill
« Reply #12 on: April 07, 2023, 11:15:06 AM »

Yep tis a proper job!
Q of Devon  ;)
Logged
Thrupenny Bit

I think I'm starting to get most of the notes in roughly the right order...... sometimes!

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Rejuvenating an old Pokerwork grill
« Reply #13 on: April 07, 2023, 11:19:01 AM »

Looks great John. That’s the old Club I, I think that has a zinc grill?.. I like the Matt look more to be honest, perhaps I should switch it round and dull the shiny corners of the box instead (They already have some harsh spots of corrosion anyway, and elsewhere on the box I had to fill woodworm holes - it’s never straight forward is it lol?)
Logged
Dancing about architecture since 1997

Graham Spencer

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3548
  • MAD as a wet Hohner........
Re: Rejuvenating an old Pokerwork grill
« Reply #14 on: April 07, 2023, 04:53:39 PM »

As a Black Country lad, you'll have to make do with bostin'  :|glug

Not quite Black Country, but I am a Midlander - Brummie to the core, and "bostin'" is definitely the right term....... ;D
Logged
Among others, Saltarelle Pastourelle II D/G; Hohner 4-stop 1-rows in C & G; assorted Hohners; 3-voice German (?) G/C of uncertain parentage; lovely little Hlavacek 1-row Heligonka; Bâ™­/Eâ™­ Koch. Newly acquired G/C Hohner Viktoria. Also Fender Jazz bass, Telecaster, Stratocaster, Epiphone Sheraton, Charvel-Jackson 00-style acoustic guitar, Danelectro 12-string and other stuff..........

Squeezing in the Cyprus sunshine

John Burks

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 142
Re: Rejuvenating an old Pokerwork grill
« Reply #15 on: April 07, 2023, 05:13:37 PM »

"Bostin" is a high compliment  :D.... thanks ... made my day   :D

Logged
Francois Dedenis D/G, Koch Overture G/C , Custom "Picoletta" D/G, Hohner Modell 1 B/C, M Hohner 5A B/E (Phosphor Bronze)

John Burks

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 142
Re: Rejuvenating an old Pokerwork grill
« Reply #16 on: April 07, 2023, 05:17:50 PM »

Looks great John. That’s the old Club I, I think that has a zinc grill?.. I like the Matt look more to be honest, perhaps I should switch it round and dull the shiny corners of the box instead (They already have some harsh spots of corrosion anyway, and elsewhere on the box I had to fill woodworm holes - it’s never straight forward is it lol?)

Hi Arnold,  Mine was simple pressed steel with a painted coating.  I think it had been worked on.  The whole box was a bit tired. Seals well though

Re the finish ...I nearly went with the matt silver coat.  The Hycote was a difficult decision  (:)

It is never straight forward  (:)
Logged
Francois Dedenis D/G, Koch Overture G/C , Custom "Picoletta" D/G, Hohner Modell 1 B/C, M Hohner 5A B/E (Phosphor Bronze)

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Rejuvenating an old Pokerwork grill
« Reply #17 on: April 07, 2023, 11:33:04 PM »

Well after all that ahem I err decided to give it the ‘worn’ look and took some p600 sandpaper to the shiny corners of the box to match the grill. Looks much better now anyway because there were some bits of corrosion and they don’t stand out so much now… Thanks for the advice! This box might even make its debut for this tune of the month, so you can see it in all its err glory!..
Logged
Dancing about architecture since 1997
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal