Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Melodeon Mics  (Read 4263 times)

0 Members and 1 Guest are viewing this topic.

Howard Jones

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1203
Re: Melodeon Mics
« Reply #20 on: May 19, 2023, 09:23:08 PM »

I've always found Thomann to be very helpful.  Try getting in touch with them and see what they suggest.

IanD

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1703
  • Too many melodeons...
Re: Melodeon Mics
« Reply #21 on: May 21, 2023, 02:36:32 PM »

It might be worth trying an EQ pedal between the box and the amp.
Roll off all the lower frequencies not needed by the box.
  Worth a shot - it might them at least useable.
Obvs this would only work on the treble side.

Unlikely to help, in my experience most mic handling noise pickup like this extends well up into the midrange where it sounds even worse than low-frequency noise... :-(

I use a stand mic for the treble end and a cheap clip-on (onto the inside of the strap) cardioid electret condenser for the bass end and have no problems... :-)
« Last Edit: May 21, 2023, 02:39:18 PM by IanD »
Logged
Oakwood Model 4 D/G, Castagnari Dony D/G/#, Castagnari Tommy G/C, Baffetti Binci D/G, Hohner Preciosa D/G, Melos Bb/Eb, Lightwave SL5 and Kala California fretless basses

JNM SY

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 227
Re: Melodeon Mics
« Reply #22 on: May 21, 2023, 04:58:27 PM »

I use a mic system I built myself inside the treble grill, powered by a pp3 9v battery through a switch and terminating in a 1/4" jack socket on the bottom of the grill. I plug In a wireless transmitter ( which can be folded towards the front out of the way) Works great.

PS. Being a wet Hohner it was a bit sharp which was easily sorted by a by my pedal, which I had already - and the tramsmitter- ( Ex guitarist)
« Last Edit: May 21, 2023, 05:03:35 PM by SHTUM »
Logged

Jozz

  • Good talker
  • **
  • Offline Offline
  • Posts: 97
  • Greetings from the Netherlands!
    • Stichting Bon Artz
Re: Melodeon Mics
« Reply #23 on: May 22, 2023, 03:15:46 PM »

Not like the forum to be so silent when posed a question.  Was it something I said?

Let's have another go:  I've previously used cheap tie-clip microphones, Microvox concertina mics, a 2-mic Myers system and an Audix flute mic.  All four have involved fixing small mics to the instrument and running them through a battery-powered pre-amp or whatever.  None of these has ever really caused a problem.

But the other day I invested in the Thomann T-bone Ovid cc100s.  Running them on phantom power (the battery pack they sent was faulty), I find an unacceptable level of noise every time anything touches the mics, clips or the first few inches of lead.  If the lead brushes against the bellows, you can hear it.  If you clip a mic to the left handstrap, it transmits every hand movement to the amp.  They're just unusable.

Am I being over-fussy?  Is this to be expected with this type of microphone.  Is it because they're cheap and cheerful?  Are better microphones shielded in some way from this kind of mechanical noise?  Being very un-techy I'd welcome any expert views.

I run the 'Lucan' equivalent, not 100% sure but I think they are the successors of the 'Ovid's'. Identical in many ways at least.

These go into rental gigs and any instrument that I can fit them on - but they have no more handling noise than any other typical 'gooseneck' system / microphone. In fact they are top-notch quality for money.

You could be running way to high gain on those with poor placement. They require very little from a decent pre-amp / mixer. If you run these with high gain into a mic pre-amp you might get the problems you describe.
Logged
Stichting Bon Artz - We present and support authentic music and small-scale performance arts.

IanD

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1703
  • Too many melodeons...
Re: Melodeon Mics
« Reply #24 on: May 22, 2023, 06:11:18 PM »

Not like the forum to be so silent when posed a question.  Was it something I said?

Let's have another go:  I've previously used cheap tie-clip microphones, Microvox concertina mics, a 2-mic Myers system and an Audix flute mic.  All four have involved fixing small mics to the instrument and running them through a battery-powered pre-amp or whatever.  None of these has ever really caused a problem.

But the other day I invested in the Thomann T-bone Ovid cc100s.  Running them on phantom power (the battery pack they sent was faulty), I find an unacceptable level of noise every time anything touches the mics, clips or the first few inches of lead.  If the lead brushes against the bellows, you can hear it.  If you clip a mic to the left handstrap, it transmits every hand movement to the amp.  They're just unusable.

Am I being over-fussy?  Is this to be expected with this type of microphone.  Is it because they're cheap and cheerful?  Are better microphones shielded in some way from this kind of mechanical noise?  Being very un-techy I'd welcome any expert views.

I run the 'Lucan' equivalent, not 100% sure but I think they are the successors of the 'Ovid's'. Identical in many ways at least.

These go into rental gigs and any instrument that I can fit them on - but they have no more handling noise than any other typical 'gooseneck' system / microphone. In fact they are top-notch quality for money.

You could be running way to high gain on those with poor placement. They require very little from a decent pre-amp / mixer. If you run these with high gain into a mic pre-amp you might get the problems you describe.

If there's too much gain then the signal level would also be too high, and would have to be turned down at the mixer. The ratio between the handling noise and signal is unchanged by the gain structure.
Logged
Oakwood Model 4 D/G, Castagnari Dony D/G/#, Castagnari Tommy G/C, Baffetti Binci D/G, Hohner Preciosa D/G, Melos Bb/Eb, Lightwave SL5 and Kala California fretless basses
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal