Well done that man! A 'proper' job.
What I think may be of interest to others is applying a point source of heat, together with wetting to soften the glued interface from INSIDE the part to be removed. Obviously no use if the part to be removed isn't damaged beyond repair already.
Some basic maths/physics ( And a very rough time estimate)
Specific Heat of Water is 4200 Joules/ kilogram/ degree C
So 4200 Joules of Thermal energy will raise 1 kg of water 1 degree centigrade
So 4.2 Joules will raise 1 g of water 1 degree centigrade
1 cubic centimetre of water weighs 1 gramme.
A power rating of 1 Watt = 1 Joule per second.
At a guess I had no more than 1 gramme of water in that rib ( its total volume was no more than 2 cubic centimetres)
25 Watt soldering iron.....estimating 16% efficiency i.e. 4 Watts or 4 Joules per second makes it to the tip of the iron
At that heat input rate the temperature of the water/wood is going to increase by 1 degree per second.
Roughly 80 seconds of heat to get to glue melting... =/- 50 %
(I think it actually took about a minute but I wasn't clock watching)