Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Reeds Beating  (Read 1583 times)

0 Members and 1 Guest are viewing this topic.

John Burks

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 142
Reeds Beating
« on: July 23, 2023, 04:26:12 PM »

Thought that this might be of interest.  It a short video of two reeds beating.  The first note that sounds (push) is from the two reeds located on the underside of the reed plates (ie. you see the valves lifting and oscillating as the air flow/pressure differential varies.)

When second note sounds (pull) it shows the reeds entering/exiting the frame and beating.  One lags slightly.  The frequencies of these upper reeds were 373.2Hz and 374.3Hz i.e. 1Hz offset.

Reed Test by John Burks, on Flickr
« Last Edit: July 23, 2023, 09:46:03 PM by John Burks »
Logged
Francois Dedenis D/G, Koch Overture G/C , Custom "Picoletta" D/G, Hohner Modell 1 B/C, M Hohner 5A B/E (Phosphor Bronze)

BoxPlayer

  • Member
  • *
  • Offline Offline
  • Posts: 31
Re: Reeds Beating
« Reply #1 on: August 05, 2023, 11:33:17 AM »

Joe Burks,
A very interesting video.
My understanding is if two reads beat against each other then the beat frequency (BPM) will be f1 minus f2 where f is the frequencies (Hz) of the individual reeds. (1 Hz = 60BPM)
Using the online beat counter I estimated this to be (approx) 120/125 BPM in your video. This suggests that your two reeds were approx 2 Hz apart.
It is also known that where two vibrating sources are close to each other one can dominate and tend to ‘pull’ the other towards it.
Logged

Chris Ryall

  • "doc 3-row"
  • French Interpreter
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 11153
  • Wirral UK
    • Chris Ryall
Re: Reeds Beating
« Reply #2 on: August 05, 2023, 02:23:34 PM »


   That’s the basic maths of it, is true of interacting pure sine waves.  A vibrating read is more complicated, and there are many harmonics going on, and roughly a saw-tooth (classically that = even harmonics only).

   we’ve discussed this quite a few times, and I’ve usually suggested somebody providean oscilloscope shot, ideally with a FFT harmonics analysis, too. Well, here’s our forums recommended tuner app, which just shows me the waveform (I think).  At minimal pressure and single reed, it looks pretty close to a sine wave to me! 

   when I draw moderately hard, again, single reed … I don’t think that’s a bad sawtooth, do you?

  I then tried the same note with two reeds.  The trace was very complex and dancing about. Didn’t seem to mean much. I’m not sure how to take this on further, but I know there are some skilled physics, and acoustics people in the forum, who probably could …  🙂
   


   
Logged
  _       _    _      _ 

BoxPlayer

  • Member
  • *
  • Offline Offline
  • Posts: 31
Re: Reeds Beating
« Reply #3 on: August 11, 2023, 10:34:59 AM »

The harmonic properties of reeds and the separate subject of two adjacent reeds playing together are well discussed in the book ‘The Electronic Music Instrument Manual’ by Alan Douglas. The reason reeds got into this ‘electronic’ book at all is because when the book was first published in 1968 air blown reeds were still a source of sound generation while making simulated, electronic musical instruments.  The book’s identification is ISBN 0 273 36193 7
Joe Burks’s video is of great interest to reed tuners in the accordion/melodeon field since many reeds, playing together are very close to each other and sometimes even sharing the same air supply chamber. 
Logged

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Reeds Beating
« Reply #4 on: August 11, 2023, 12:03:37 PM »

"here’s our forums recommended tuner app"

Which tuner app is that, please? I've seen quite a few which have been recommended, and have used a couple (obviously the cheaper/free ones!). But I haven't seen that sort of display before.
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Reeds Beating
« Reply #5 on: August 11, 2023, 12:25:45 PM »

"here’s our forums recommended tuner app"

Which tuner app is that, please? I've seen quite a few which have been recommended, and have used a couple (obviously the cheaper/free ones!). But I haven't seen that sort of display before.

I don’t think there is a “forum recommended tuner app”

There are several that have been suggested by various people. The one you prefer will depend on how you want to use it, so if you want a waveform or a frequency spectrum like Chris above your needs are different from someone who just wants the most accurate readable display of pitch.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5055
  • Windjammer
    • Wesson Accordions
Re: Reeds Beating
« Reply #6 on: August 11, 2023, 12:58:06 PM »

I can highly recommend the Airyware tuner app.
Logged
Rees Wesson (accordion builder and mechanic)
Gungrog, Welshpool, Wales, UK
www.melodeons.com

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Reeds Beating
« Reply #7 on: August 11, 2023, 01:11:19 PM »

Yes it’s a good tuner, but I couldn’t get on with it.  My preferred tuner is Peterson iStrobosoft.  Others swear by  Dirks tuner.  Ben Farmers freebie is good too.  Yer pays yier money and yet takes yer choice! 
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Chris Ryall

  • "doc 3-row"
  • French Interpreter
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 11153
  • Wirral UK
    • Chris Ryall
Re: Reeds Beating
« Reply #8 on: August 11, 2023, 01:15:39 PM »


   correction. it was “Rees recommended”.  I’ve switched and I’m very happy with it 🙂
Logged
  _       _    _      _ 

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Reeds Beating
« Reply #9 on: August 11, 2023, 01:16:10 PM »

I've just been looking at the Airyware thing, and I'm currently using the Farmer's one. I seem to have lost the Peterson tuner somehow. (After actually paying for it as well!)
Thanks for the replies.
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

BoxPlayer

  • Member
  • *
  • Offline Offline
  • Posts: 31
Re: Reeds Beating
« Reply #10 on: August 11, 2023, 06:14:14 PM »

Thanks to Theo who points out the difference between simply measuring a reeds frequency (Hertz) and a reeds harmonic content (spectrum analyser).
Regarding two reeds of different frequencies playing at the same time and generating 'beats' the only tuner (to my knowledge) which can 'listen' to two (or more) reeds at the same time is Dirks Tuner.
My tuppence worth is that I use the online/phone app. tuner called 'pitchlab'  which I find is stable and accurate and reads to a 1/10th of a Hertz and a Cent. 
Logged

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Reeds Beating
« Reply #11 on: August 11, 2023, 07:30:45 PM »

Bill Farmer's Tuner reads more than one reed at a time.
I find it invaluable for tuning chords, and the two reeds creating the tremolo. It might show beats but I haven't worked out how, though you can see what the offsets are and you can listen to the beats
The more you do it the more you understand the relationship between differences in cents, pitch and beat frequency.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

BoxPlayer

  • Member
  • *
  • Offline Offline
  • Posts: 31
Re: Reeds Beating
« Reply #12 on: August 12, 2023, 10:13:26 AM »

Squeaky Pete:
That's interesting about Bill Farmer's Tuner.  I prefer a tuner that will run on the phone as my computer is less accessible and distant from my workbench.
If it displays the Hertz frequency of each reed then the beating rate is a simple calculation:  eg. If one reed is at 440Hz and the other is at 441 then the beating rate is   441 - 440 = 1 beat per second.
If it can deal with a chord (3 reeds?), all at once, as you say, this would be really useful for bass end tuning.
Logged

Chris Ryall

  • "doc 3-row"
  • French Interpreter
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 11153
  • Wirral UK
    • Chris Ryall
Re: Reeds Beating
« Reply #13 on: August 12, 2023, 10:38:09 AM »


   Still can’t find a “Bill Farmer” tuner on Apple AppStore.  It looks to be one of the GitHub projects. And much more about tuning than actually looking at the sound itself.  I’m happy with Reese’s recommendation for that purpose, particularly as I never tune reeds myself.

  basically, I need a straightforward FFT app with simple plot by frequency to satisfy my acoustic curiosity. There are several available ranging in price from 99p to £19.99.

   there used to be a video of Bill’s tuner in action (discussed here 2021) but it seems to have been taken down
Logged
  _       _    _      _ 

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Reeds Beating
« Reply #14 on: August 12, 2023, 10:43:28 AM »


   Still can’t find a “Bill Farmer” tuner on Apple AppStore.  It looks to be one of the GitHub projects.

As far as I recall it was never available for mobile or tablet, only for desktop and it appears to be still available for download fromGitHub.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

-Y-

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 896
  • Handry 18 (G/C), Mélodie (D), Club IIb (A/D)
    • a database of nearly 500 melodeons here
Re: Reeds Beating
« Reply #15 on: August 12, 2023, 11:10:01 AM »

Actually it's available for Android phones here:
https://f-droid.org/packages/org.billthefarmer.tuner/

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Reeds Beating
« Reply #16 on: August 12, 2023, 01:50:11 PM »

I've been using it successfully on an Android phone for quite some time. It's pretty well dummy-proof!
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Re: Reeds Beating
« Reply #17 on: August 12, 2023, 02:12:54 PM »

If it can deal with a chord (3 reeds?), all at once, as you say, this would be really useful for bass end tuning.
That is exactly what I mean.
Obviously it's the ± cents readings that is used. The graphical display cannot discriminate between 3 different pitches.
One thing it's not good at is tuning two octaves of bass reeds. A slightly different approach is needed here.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal