It's even more involved than has already been stated - unfortunately.
There are (at least) three components here: text annotations, accompaniment chords and (as the word was used) 'symbols'
(
s: lines). Very briefly:
Text annotations are (at their simplest) bracketed as
"^text" (above) or
"_text" (below). I think this is what Hugh is actually
asking about? If that is the case, stop reading
now - the rest of this stuff is just me, showing off!
Accompaniment chords are bracketed as
"chord name" - this means that
"G" in the earlier reply is an accompaniment chord,
not a text annotation - it will probably sound as a G chord on playback. To get them below the staff use
%%pos gchord belowSymbols are used in
s: lines to remove 'clutter' from ABC music lines. From memory, they are 'tied' to accompaniment chords
in the sense that changing the accompaniment chord font, or position will have the same effect on the
s: lines.
Later edit after consulting the manual:s: lines are intended to be used to separate 'symbols' from 'music' eg:
!>! !f! !p! !mp! (as mentioned by PD). Cunning coding
also allows you to (mis-)use
s: lines to encode simple tablature. The rules for alignment/placement of 'symbols' relative to the
accompanying 'music' lines are similar to the rules for
w: lines (I tried this as an experiment a couple of weeks ago for concertina
tabs - the tabs are analogous to 'dummy' lyrics in
w: lines), but keep them above the staff. I haven't yet explored the use of
s: lines fully, so this may be a bit 'flaky'..
All of this is described in GG's 'Making Music with ABC2' manual
https://abcplus.sourceforge.net/abcplus_en.pdf_______________________________________________
I think I got most of that right. I may be picky, but IMO it's important to get the first two of these sorted out, particularly if you use playback at all.
(Not so important if you don't use playback.)