Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Isolating reed banks in a 1040  (Read 800 times)

0 Members and 1 Guest are viewing this topic.

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Isolating reed banks in a 1040
« on: January 12, 2024, 05:06:34 PM »

If I am going to try to tune the worst reeds on the 1040 myself, how do i best isolate the two reed banks? Easy with a stopped box and for rough tuning (all I am planning to attempt just now) you can take the treble blocks out of a 2 row.....but you can't do that with the flat mounted plates on a typical 2 voice 1 row.

So how? I have no chance of getting to most of my tools or tuning table for some weeks.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Isolating reed banks in a 1040
« Reply #1 on: January 12, 2024, 05:14:46 PM »

If the valves are newly glued I use a strip of masking tape over the top of the reeds. Requires care when removing to avoid damaging the valves.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

tirpous

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1403
Re: Isolating reed banks in a 1040
« Reply #2 on: January 12, 2024, 05:58:06 PM »

It's also possible to place a strip of paper or low-tack masking tape (covering the holes for the unwanted reed bank) under the pallets.  Use 2 slats of wood (1 to depress all buttons and 1 to protect the back of the fingerboard) and 1 or 2 spring clamps to lift all pallets simultaneously to allow easy positioning of the paper.
Logged

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: Isolating reed banks in a 1040
« Reply #3 on: January 13, 2024, 11:00:11 PM »

It's also possible to place a strip of paper or low-tack masking tape (covering the holes for the unwanted reed bank) under the pallets.  Use 2 slats of wood (1 to depress all buttons and 1 to protect the back of the fingerboard) and 1 or 2 spring clamps to lift all pallets simultaneously to allow easy positioning of the paper.
Done successfully using a folding carpenters ruler to hold down all buttons at once, and a strip cut off the bottom of a A4 sheet of file paper. Tomorrow I will try to plot the frequencies ....maybe.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal