Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Does anyone have one of these? (Old Hohner Part)  (Read 618 times)

0 Members and 1 Guest are viewing this topic.

Ross Dubois

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 144
Does anyone have one of these? (Old Hohner Part)
« on: February 22, 2024, 04:21:06 PM »

I'm struggling to find something that quite fits the bill, but I need another one of the items I've pictured below. It's a nut that affixes the action to the body of the accordion. I think it's about 24tpi I think and would mount a screw/bolt approximately 2.8mm thick.
The base of the mating surface is about 7.5mm. that's important as this fits into a small circular section in the action board.

If there's another like this out there, amazing, but if there's a substitute that doesn't quite match I'll take it!



Logged

xgx

  • Bagpipes & Musette Boxes... and Banjos, luv 'em!
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1157
Re: Does anyone have one of these? (Old Hohner Part)
« Reply #1 on: February 22, 2024, 04:39:58 PM »

Check if you have a model engineering club nearby, they'll probably make you one.
Have you checked the Chinoiserie sites, Temu, Ali-wotnot, they do all sorts
Logged
Graham

Socio-Demographic:   Graduate, Coffin Dodger
 Location: N Cambs/S Lincs - UK

Mick

  • Good talker
  • **
  • Offline Offline
  • Posts: 55
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal