Hi All,
I'm going full-monty on my soviet box hot rod, and I'm rebuilding the left side mechs right now.
There's a video where somebody uses rubber tubing to reduce the roller mech noise:
https://youtu.be/p-LUNY97-Ww?t=97The end result looks quite similar to what's inside some stradella mechs, however, the guy in the video just leaves the oversized rubber tubing hanging on the linkages.
A neater way would be to either use heat shrink, or pick the tubing in the same diameter as the rods.
My rods measure in at 1.57mm, so there's a choice of either natural latex with 1.6mm hole, or 3.2mm heat shrink that will end up hugging the 1.6 rod.
Does anyone have any experience using heatshrink for this job? Is there a risk of the shrink walls getting worn out with use and needing replacement? Similarly, are there any reasons to go/not to go for natural latex?
Thank you.
Thank you.