Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: DIENST INTERNATIONAL BELLOWS TAPE RENEWAL  (Read 770 times)

0 Members and 1 Guest are viewing this topic.

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
DIENST INTERNATIONAL BELLOWS TAPE RENEWAL
« on: March 16, 2025, 02:18:31 PM »

I have known for a long time that I would have to replace the bellows tape on the bottom of my 21/6 A&D before the knee wear got through to the bellows papers themselves.

That day has arrived.

What I didn't expect when I began to dampen and peel back the buckram tape was to find that each fold is taped with one continous piece of tape, with holes cut through at the corners rather than each side being taped with a seperate tape length.

Not quite sure how best to proceed. I had envisaged just stripping the worn through tapes, mainly off the bottom of the box and leaving the rest as original.
I have never before seen a single length of tape wrapped right round the bellows.

Is this actually a common bellows tape detail?

Photographs attached

Logged

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: DIENST INTERNATIONAL BELLOWS TAPE RENEWAL
« Reply #1 on: March 16, 2025, 03:11:21 PM »

For information - The old tape is a finer material than I have seen on other instruments of this vintage and is 3/4 inch wide. I am not sure whether the glue is gum arabica or hide glue but though embrittled  it does soften and become tacky with dampening.
Logged

tirpous

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1403
Re: DIENST INTERNATIONAL BELLOWS TAPE RENEWAL
« Reply #2 on: March 16, 2025, 03:41:43 PM »

Can you do a right angle cut on the lower end of the side tape and replace bottom tape in normal fashion ?

Some older Quebec 1-rows had tape all-around, but no metal corners.

Logged

Peadar

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2039
Re: DIENST INTERNATIONAL BELLOWS TAPE RENEWAL
« Reply #3 on: March 17, 2025, 11:29:32 AM »

Can you do a right angle cut on the lower end of the side tape and replace bottom tape in normal fashion ?

Some older Quebec 1-rows had tape all-around, but no metal corners.

I am thinking along those lines. maybe actually peeling and cutting some of the tapes back to leave the corner detail and overlapping the new taped section slightly.
I have realised that the tapes of the three folds nearest the treble cabinet are sufficiently unworn that they don't need replacing so I can leave them as original
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal