Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Reed gapping and slot embossing  (Read 361 times)

0 Members and 1 Guest are viewing this topic.

kenakordeon

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 264
Reed gapping and slot embossing
« on: October 02, 2025, 06:55:52 PM »

 I usually do both to improve the reed response and sound on my harmonicas. Does anyone do either of these to melodeon reeds and reed plates? Both would be easy enough to do on the outer/facing reed plates but I can't see how either could be done on the inner reed plates unless the plates were to be removed from the blocks.

Anyway, just wondering about anyone's experience trying either.

Ken
Logged

mChavez

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 713
Re: Reed gapping and slot embossing
« Reply #1 on: October 02, 2025, 07:09:45 PM »

Gapping - absolutely.
Rolling /embossing/chiselling - yes, but it's not usually required on top quality reeds. I really like vintage hand-made reeds for their timbre and they often can benefit from a roll & a chisel.

Plates have to come off. I don't get the (rather common) fetish of trying to work on a reed plate while it's waxed in. It takes 2 minutes to wax off, then wax on a plate.
« Last Edit: October 02, 2025, 07:11:56 PM by mChavez »
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Reed gapping and slot embossing
« Reply #2 on: October 02, 2025, 10:09:29 PM »

Yes gapping is a standard part of my reed fettling.  When I’ve tried embossing I’ve been unsuccessful mainly because better quality reeds are usually on quite a hard Al alloy plate which is difficult to deform. It could be a useful way to improve cheaper reeds on soft Al plates.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

kenakordeon

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 264
Re: Reed gapping and slot embossing
« Reply #3 on: October 03, 2025, 01:07:33 PM »

Thanks for your replies. I have one melodeon with a few reeds which seem to respond only to strong air pressure. Possibly gapping will help.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal