I finally joined the Liliput club after spotting one in a local auction. I've had it for less than 24 hours and I already love it, but the size, action and bellows flexibility are going to take a bit of getting used to! It's clearly been played a lot, much of the bellows tape is worn off and certain reeds - and the inside of the bellows near the air button - are caked in grey muck. One particular bellows fold, about a third of the way along from the treble side, has suffered a lot. The front top corner is all floppy, and the back top corner is covered in gumstrip and leaking quite badly. I don't know much about consolidating bellows - is this repairable? I feel like if the worst comes to the worst I could carefully cut out that entire fold and graft the two sides back together with bookbinder's tape, leather etc, but I'd rather not do that if it isn't necessary. The folds either side of this one also look a bit dodgy but not nearly as bad, and the rest of the bellows seem fine. At least the previous repairs were done with hide glue and gumstrip which is a pleasant change from the gaffer tape and PVA messes that I'm used to!