Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Reeds manufacturing  (Read 370 times)

0 Members and 1 Guest are viewing this topic.

Squeaky Pete

  • Squeaky Pete
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1327
  • Re-hohn a Hohner
Reeds manufacturing
« on: March 14, 2026, 09:33:27 AM »

This is something I've wondered about for a while and touched on it in another thread.
Looking particularly at Hohner reeds, but having noticed the same thing on other makes, are the reed plates manufactured using the same tongues on each side.
The lower pitched tongue seems to look identical to the other side apart from having a deeper scoop ground out near the root.
Are they all made like this or do the best reeds have different gauges of steel on each side?
Big bass reeds seem to be made of maybe 3 different tongue thicknesses and again only the grinding transforms it.
Obviously the high reeds with different length tongues must be more dedicated sizes.
Logged
Poker work DG.
Pariselle 2.6 DG, Ex-Club IIIBS CF,
Matching Liliputs in CF and DG,
Lots of sickly Hohners needing TLC,
Bassoon, Various Bagpipes........

mChavez

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 713
Re: Reeds manufacturing
« Reply #1 on: March 20, 2026, 07:58:53 AM »

Old-school, high end, hand-made Russian bayan reeds typically had a unique length for each note.
As did the high end brass reeds that I had in my old Belgian Solari.

At some point factories figured out that they can standardise reed length over several semitones (3 I think) without losing any sound & response quality - e.g. top of the line, a-mano Cagnoni reeds in my flagship Excelsior CBA had some standardisation, yet, played beautifully.
Cheaper end production is just a balance of how much cash they can save by not doing it properly, vs how much sound deterioration they are willing to accept in a cheaper product.

Steel gauge seems to vary a lot and I see it just as means of getting the right pitch for the given length & desired profile & stiffness.
« Last Edit: March 20, 2026, 08:07:02 AM by mChavez »
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal