Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Bellows frame surface prep for new gaskets  (Read 322 times)

0 Members and 1 Guest are viewing this topic.

Torre13100

  • Member
  • *
  • Offline Offline
  • Posts: 4
Bellows frame surface prep for new gaskets
« on: May 06, 2026, 04:01:10 PM »

Hi all,

​I’m currently replacing the bellows gaskets on my Hohner Erica to improve the compression.

​I’ve just removed the old treble gasket, but as you can see in the attached photo, some of the black finish/paint from the plastic frame came away with the old adhesive.

​My main priority is functionality and getting the best airtight seal possible. Before I apply the new 5mm x 2mm foam gasket:

​Does this surface need to be repainted or leveled out with a light sandpaper?
​Or is it better to just clean it thoroughly with alcohol and stick the new gasket directly onto the bare plastic areas?

​I'm worried about creating an uneven surface that might leak, but I also don't want to add layers of paint that might cause adhesive issues later.

​Thanks in advance for any advice!
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Bellows frame surface prep for new gaskets
« Reply #1 on: May 06, 2026, 04:26:04 PM »

The gasket material will easily adapt to those irregularities.  Just make sure there is nothing loose or powdery.  I’ve just replaced the gasket on a very similar Hohner and it’s completely airtight.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

chris hall

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 245
Re: Bellows frame surface prep for new gaskets
« Reply #2 on: May 06, 2026, 11:10:04 PM »

i like to scrape with a blunt knife. then wirebrush. the make sure all corner joints arent loose or coming unglued. than apply foam without stretching as taught to me by rees wesson. works for me.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal