Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: 2915 gold foil version history?  (Read 473 times)

0 Members and 1 Guest are viewing this topic.

MikeSchway

  • Member
  • *
  • Offline Offline
  • Posts: 11
2915 gold foil version history?
« on: May 09, 2026, 06:33:35 PM »

Hi, all.

I've recently acquired two gold foil 2915s, and they're outwardly very similar except:

One accordion (the older one) has black bellows tape; reed blocks have a felt gasket glued to their soles; and the blocks are secured via long z-shaped stiff wire clamps threaded directly into a tall block at the end of the soundboard and swung over the reed block to secure it. 

The other one (newer) has gold bellows tape, there's a leather-like gasket glued to the soundboard with the blocks having a bare sole plate, and the blocks are secured with a small rectangular sliding clamp whch is screwed into a much lower end block. 

Both instruments have T reeds on treble and bass, orange bellows folds, and plastic keyboard housings. 

My questions:
1). Did all three changes (Z-wire vs smaller block clamp, felt-on-block vs leather on soundboard, and bellows tape) happen at the same time and if so, about when did this happen?

2) I can see where some energy could be lost with a felt gasket on the block vs a harder, thinner leather gasket on the soundboard because of flexibility and maybe even a little air loss within the felt.  These are two very different sounding instruments with the older one not quite as loud and a little more mellow.  Does reed mounting method immediately translate to bright and loud vs softer/more-mellow tone?

3).  (bonus, unrelated question).  Is a dryish swing voicing a bad idea for a 2915 if I want to keep a little bit of smoothness, but still want it to sound "in tune"? 

Thanks in advance,
--Mike

Obligatory arsenal disclosure:  Marc Savoy "Acadian" x3, Corona II x2, 2915 x 4, Lisheen C#/D, Hohner Merlin DG

Logged
--Mike Schway
Bellingham, WA US

Personal arsenal:  Marc Savoy Acadian (C,D, wet D), Corona II (60s GCF, newer GCF and FBE), Far, FAR too-many pokerworks (GC, AD, DG), Erica GC, Castagnari Dinn3 C#D, Merlin DG, Lisheen C#D

Malcolm Clapp

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1119
  • Loving my Hohner-reeded wet MMM CastaTommy
Re: 2915 gold foil version history?
« Reply #1 on: May 19, 2026, 01:56:23 AM »


1). Did all three changes (Z-wire vs smaller block clamp, felt-on-block vs leather on soundboard, and bellows tape) happen at the same time and if so, about when did this happen?


I believe that the introduction of all of these "improvements" (????) would have taken place at some time during the period from the early 1960s to the early 1990s. I doubt they would all have taken place at the same time (day, week, month, year, or even decade).

Two likely reasons for the changes; the earlier parts concerned may have been supplied by independent manufacturers who may have ceased production, or, for whatever reason, were unable to continue supply; alternatively, they may have been simply cost-cutting and/or time-saving measures.

I can see no other justification for the repositioning of the gasket beneath the reedblocks, nor the application of the (lesser quality) later bellows tape, though I suspect the purpose of the change in design of the reed block anchors was maybe just because it looked more like an engineering solution than the relative simplicity of the original Z type.

Just my take on your first question; others here may have different opinions....
« Last Edit: May 19, 2026, 02:02:16 AM by Malcolm Clapp »
Logged
Tuner/repairer, now retired.
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal