Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Super glue and celluloid  (Read 5472 times)

0 Members and 1 Guest are viewing this topic.

boxlad

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 291
    • Ray Ó Díomasaigh
Super glue and celluloid
« on: March 30, 2010, 04:04:11 PM »

I remember reading somewhere the effect of certain chemicals on celluloid and the drastic results that ensued! Would super glue have any bad effect on celluloid? A small section of the black piping around the celluloid is lifting off one of my accordions and needs to be glued back in place.. any suggestions apart from super glue or will it do the job nicely???
Logged

Quebecois

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1206
  • Accordez-vous donc, c'est si beau, l'accordéon!
Re: Super glue and celluloid
« Reply #1 on: March 30, 2010, 04:46:57 PM »

I use Crafter's Goop to solve most of my sticky problems. Name may vary depending on the country!
Logged
Hohner Morgane D/G, pre-Erica Hohner in C/F and G/C,
Hohner Erica A/D, Roland FR-18

Lars

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 797
Re: Super glue and celluloid
« Reply #2 on: March 30, 2010, 05:58:15 PM »

Evo-stick impact glue (available in Ireland from Woody's DIY) is nice for most jobs, since you can dip a q-tip in it, and carefully place the glue where you want it - you've got about 30 seconds before the glue starts to thicken. This glue could do the trick, since it's strong, does not get brittle, and does not harm celluloid. If you get it wrong, wait a few minutes, and work it off with your fingertip.

For the plastic stuff thin superglue is also good, since it welds the two surfaces together. I've used it for the piping on a handfull of paolo sopranis. The trick is to be careful to get it ONLY where you want it.
Logged

Quebecois

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1206
  • Accordez-vous donc, c'est si beau, l'accordéon!
Re: Super glue and celluloid
« Reply #3 on: March 30, 2010, 06:48:28 PM »

Superglue must be used with EXTREME care, in minute quantities! It runs easily on shiny surfaces and will ruin most glossy finishes. One of its drawbacks is that it does not fill spaces like epoxy, Gorilla or Sumo glue do. Silicon does a good job too, and it comes in clear, black and sometimes other colors.
Logged
Hohner Morgane D/G, pre-Erica Hohner in C/F and G/C,
Hohner Erica A/D, Roland FR-18

boxlad

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 291
    • Ray Ó Díomasaigh
Re: Super glue and celluloid
« Reply #4 on: March 31, 2010, 12:24:51 PM »

Thanks for the advice friends. Once again some sound advice from experts at melodeon.net. I'll consider my options now and hope for the best!
Logged

Lars

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 797
Re: Super glue and celluloid
« Reply #5 on: March 31, 2010, 03:39:36 PM »

Re-checking my boxes over today, I found another loose piece of trim. I used superglue:

1: Carefully lifting the trim about 5-7 mm off the surface in the end where it had come off.

2: Using a small-nozzled superglue I carefully dripped a single drop of glue under the trim.

3: Press hard for 5 seconds.

Now it's safe and sound again. The old glue residue will still be there, so the two surface match up perfectly. Mind you, I only used a very small drop of glue, and took great care to have plenty of light to ensure that the glue was not getting on any surface other than the intended!
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal