Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Repair / restoration: workmanship quality expectations  (Read 3649 times)

0 Members and 1 Guest are viewing this topic.

GanAinm

  • Member
  • *
  • Offline Offline
  • Posts: 32
Repair / restoration: workmanship quality expectations
« on: April 15, 2010, 01:15:33 PM »

While checking over a refurbished Hohner Black Dot, recently puchased online as a restored instrument, I got to thinking about what quality of workmanship (workwomanship doesn't sound quite right) one should reasonably expect in an instrument costing less than £300.

Do you think any, or all, of these issues are acceptable in an instrument costing less than £300?
- mix of T and H reeds on one reedblock
- T and H reeds opposite each other, i.e. on the same note.
- reed nails not replaced after re-waxing
- note names and/or other marks etched into the reeds
- mis-aligned pallets, leaving small air gaps
- bellows frames which originally belonged to a different instrument
- reed blocks which originally belonged to a different instrument

At what price point do you think it would be reasonable to expect that an instrument offered for sale would not have these issues (unless previously mentioned)?

Do you think that any of these are non-issues, i.e. perfectly acceptable in any instrument, regardless of price?

Do you think that any of these are critical issues, i.e. never acceptable in any instrument, regardless of price?
« Last Edit: April 15, 2010, 06:38:20 PM by GanAinm »
Logged

LJC

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 527
Re: Repair / restoration: workmanship quality expectations
« Reply #1 on: April 15, 2010, 08:40:38 PM »

No reed nails is completely acceptable, regardless of price - loads of really expensive boxes are just waxed.

I wouldn't be worried about mixed reeds if the tuning was good and they were matched to sound good together. The location along the block and the block its self has a good deal to do with sound (along with everything else) in comparison to the reed. I've done repairs on boxes and put better H stamped reeds in a mostly T box (admittedly on chords so the audible difference is negligible). Two reeds are never identical anyway - checking for balance and adjusting tuning, tongue height etc is probably more important.

Reclaimed parts is also fine in my book, assuming it a) looks ok and b) fits properly with no air leak issues. Notes on the reed blocks would be ok too. I would be a bit worried about the job overall if the tuner needed to write or etch the reed plates - it's not much work just to put them in the right order on a sheet of paper and write the notes next to them if need be.

In defense of who ever you got it from, you don't know the state the box may have been in - they could have just re used the parts it came with originally if it had a mix of reeds which had been scratched on etc. Again, I would be ok with this (or doing it for a customer) as long as the final product met my standards. Are you disatisfied with your box because it sounds bad? It's not what you expected? Is there another issue?

Miss-aligned pallets is inexcusable, regardless of price, its a 2 second fix and really crucial!
Logged

oggiesnr

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 995
  • Dino BPII, Alfred Arnold Bandoneon, Loffet G/C
Re: Repair / restoration: workmanship quality expectations
« Reply #2 on: April 15, 2010, 10:04:00 PM »

Bottom line is does the instrument play like you would expect an instrument costing that to play?

It also opens a whole can of worms as to what you expect a skilled craftsman to charge per hour and how many hours £300 (less the cost to them of the instrument) buys.  If it were a professional restoration I would expect to see a reserve that reflects that, if it's an amateur restoration then I think my first question is valid.

Steve
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repair / restoration: workmanship quality expectations
« Reply #3 on: April 15, 2010, 11:15:38 PM »

I agree complety with LJC and would only add that Hohner produced many nixes with mixed H  and T reeds, and even mixed zinc and aluminium plates, so it's not a problem if the sound is balanced.

In my opinion £300 is cheap for a professionally restored Hohner two row.  New price for an Erica is now around £700.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

GanAinm

  • Member
  • *
  • Offline Offline
  • Posts: 32
Re: Repair / restoration: workmanship quality expectations
« Reply #4 on: April 16, 2010, 11:50:15 AM »

Many thanks.

I totally agree that £300 is very little for an instrument that plays and sounds great.

The issue I am grappling with is how much investment (of time and money) is it reasonable to expect a restorer to put into restoring an instrument which will be sold for such a small amount of money.

In my own case, when working on an instrument, I work slowly and probably put too much emphasis on keeping it as close as possible to it's original state. I realise that in order to have any chance of making this type of work economically viable, I will need to think more in terms of what needs to be done, rather than what would be nice to do.

I don't understand why the market price for restored old accordions is so low, while the market price for restored old concertinas is high. Perhaps it may have something to do with the fact that the top vintage concertina brands are no longer available as new instruments, while some of the accordion brands have been devalued by mass production.

Logged

HallelujahAl

  • Guest
Re: Repair / restoration: workmanship quality expectations
« Reply #5 on: April 16, 2010, 01:01:26 PM »

Quote
I don't understand why the market price for restored old accordions is so low, while the market price for restored old concertinas is high. Perhaps it may have something to do with the fact that the top vintage concertina brands are no longer available as new instruments,

As a hobbyist restorer of vintage concertinas I'm of the opinion that the relatively 'high' price for vintage concertinas is in fact because of the very limited amount of new instruments and the very, very high price of equivalent quality boxes. You get a lot of vintage concertina for £1000 or so - whereas in the new market unless one is prepared to go for accordion reeded Chinese-made models - you're looking at a very large amount of money and a long waiting list! So the vintage concertina market is holding up relatively well. If a manufacturer came along and started mass producing decent quality concertinas with proper concertina reeds and real leather bellows at a reasonable price the market for restored 'tinas would undoubtedly dip. However, that's unlikely to happen. The best thing since sliced bread as far as I am concerned is the introduction of the Jack, Jackie & Rochelle range of concertinas made by Concertina Connection (Wm Wakker et al) - and available from our very own Theo Gibb here. They're still accordion reeded instruments - but at least they're of a decent quality and give newcomers to the concertina a chance to get their hands on what looks and feels and almost plays like a real concertina before deciding to go to a dealer and upgrade to one of my beautifully and lovingly restored vintage instruments  ;D
Having said that I've been so busy this year with my proper job that I've only managed to finish four instruments so far this year - two English & two Anglo. Maybe availability is also pushing up the price - what do you think Theo???
AL  ;D
Logged

Scallyanglo

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 106
  • Baffetti/Oakwood Binci Pariselle 2.6 LM 14 bass
Re: Repair / restoration: workmanship quality expectations
« Reply #6 on: April 16, 2010, 01:09:22 PM »


Miss-aligned pallets is inexcusable, regardless of price, its a 2 second fix and really crucial!

Hmmm - my Baffetti has one - from new. I'm hoping to fix it myself as Theo assured it was easy at M&M! Do I need to get a soldering iron to heat the wire to melt the wax or would a hot piece of metal do it?
Logged

LJC

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 527
Re: Repair / restoration: workmanship quality expectations
« Reply #7 on: April 16, 2010, 01:25:26 PM »

Depends on the alignment problem - if its out vertically you can heat the metal to soften the glue and move it up a shade. If it is miles off then its probably best removing it, clean the glue off, replace and re glue.

If its misaligned horizontally you can just bend the metal arm back into place.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repair / restoration: workmanship quality expectations
« Reply #8 on: April 16, 2010, 08:33:48 PM »

Going back to the or
Many thanks.

I totally agree that £300 is very little for an instrument that plays and sounds great.

The issue I am grappling with is how much investment (of time and money) is it reasonable to expect a restorer to put into restoring an instrument which will be sold for such a small amount of money.

FWIW my approach to rebuilding old melodeons is based on the fact that its unusual to find much else apart from old Hohners that are worth the effort, so the following applies to hohners and a full rebuild normally includes:

Strip all reeds off treble and bass blocks, clean, renew valves, rewax, tune
Remove all pallets and reface with felt and leather
Replace any non standard parts, eg improvised springs
bush bass buttons with felt (only mushroom bass buttons)
limit treble action
repair bellows as required
fit new bellows gaskets
replace straps if scruffy
fit strap brackets

I find I can readily sell a Hohner rebuilt as above and in reasonable cosmetic condition for up to £450

Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

strad

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 418
Re: Repair / restoration: workmanship quality expectations
« Reply #9 on: April 17, 2010, 11:36:46 AM »

Thanks Theo, You've just listed the work order I'm intending starting in the next week. Is that the order you usually do these things?

Nigel
Logged

waltzman

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 943
Re: Repair / restoration: workmanship quality expectations
« Reply #10 on: April 17, 2010, 01:15:06 PM »

Going back to the or

bush bass buttons with felt (only mushroom bass buttons)


I'm curious as to why you don't bush the Erica type bass buttons.  I would think it would help reduce the rattling of them also.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repair / restoration: workmanship quality expectations
« Reply #11 on: April 18, 2010, 01:02:14 AM »

The order I do things varies depending what job I fancy tackling first.  I usually put off bellows taping till last,  it's I job I don't like.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

strad

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 418
Re: Repair / restoration: workmanship quality expectations
« Reply #12 on: April 18, 2010, 02:03:18 PM »

Theo - that's true dedication to this forum - answering questions at one in the morning! Thanks.

Nigel
Logged

GanAinm

  • Member
  • *
  • Offline Offline
  • Posts: 32
Re: Repair / restoration: workmanship quality expectations
« Reply #13 on: April 21, 2010, 05:37:12 PM »


I find I can readily sell a Hohner rebuilt as above and in reasonable cosmetic condition for up to £450

Thanks, £450 gives a little more room.

« Last Edit: April 28, 2010, 08:44:39 AM by GanAinm »
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal