Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: reeds on the bass side  (Read 3825 times)

0 Members and 1 Guest are viewing this topic.

JimJ

  • Good talker
  • **
  • Offline Offline
  • Posts: 59
reeds on the bass side
« on: June 11, 2010, 07:01:24 PM »

Ok, another odd newbie question.

What is the normal reed set up on the bass side of a melodeon?

The reason I ask, is that I have seen melodeons advertised
as 2 reed instruments that had stops on the bass side to remove
thirds and low bass. Apparently the bass side of these instruments
have more than 2 reeds per button, or there would be nothing left.
Thanks --- JimJ
Logged

Stiamh

  • Old grey C#/D pest
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3611
    • Packie Manus Byrne
Re: reeds on the bass side
« Reply #1 on: June 11, 2010, 08:37:39 PM »

I don't know exactly how many reeds are "normally" involved but I think I can clear up your confusion - and if I am mistaken others will quickly set us both right.

First, the two sets of reeds in the description of the box are on the treble side and thus have nothing to do with the basses.

Second, the thirds that are removed by one of the stops on the bass side are the thirds in the chords (sounded by pressing by the higher (nearer the chin) button in a bass-chord pair).

For example, a G major chord contains the notes of G (1st degree of the G major scale), B (third degree) and D (fifth degree). The B is what makes it a major chord (G minor would have Bb). If you remove the third (block off the air supply to the B or Bs) then the chord is "open" and can serve in place of a major or a minor chord. This is what the stop does - converts all the chords to open or neutral versions in which only the first and fifth degrees of the scale are sounded.

Third ( (:) ), on most boxes the bass note (operated by the lower button of a bass-chord pair) will have reeds in two octaves (e.g. a lowish G and a G an octave lower than that). The stop to remove the low bass blocks the air to the lower one(s), lightening the sound.

Hope this helps

JimJ

  • Good talker
  • **
  • Offline Offline
  • Posts: 59
Re: reeds on the bass side
« Reply #2 on: June 11, 2010, 09:14:29 PM »

Ok, think I got it.

I undersood that when the a melodeon is described as 2 reed they are talking about the treble side.

On the bass note is made up of 2 reeds, one an octave low, and the bass stop silences the low one.

The notes of the chord could also have two reeds each, but the thirds stop doesn't silence a reed,
it silences a complete note, including any and all reeds involved.
Logged

juker

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 838
  • Hohner 2 row G/C and C/F,
    • Julie's Art'nAll
Re: reeds on the bass side
« Reply #3 on: June 11, 2010, 10:31:35 PM »

Ok, think I got it.

I undersood that when the a melodeon is described as 2 reed they are talking about the treble side.

On the bass note is made up of 2 reeds, one an octave low, and the bass stop silences the low one.

The notes of the chord could also have two reeds each, but the thirds stop doesn't silence a reed,
it silences a complete note, including any and all reeds involved.

Thanks Steve! Very clear explanation. I wondered what the point of 'stopping' the thirds was. That makes a lot of sense. Do some people 'stop' the thirds themselves (even if the box isn't set up to do it) so that the chords can be more 'open'?
Logged
I don't get 'jigs'

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: reeds on the bass side
« Reply #4 on: June 12, 2010, 12:29:45 AM »

Ok, think I got it.

I undersood that when the a melodeon is described as 2 reed they are talking about the treble side.
correct
Quote
On the bass note is made up of 2 reeds, one an octave low, and the bass stop silences the low one.
Correct for Hohners and a few small size boxes, but most Italian boxes have three reeds in each bass, the bass stop, if fitted always disables the lowest reed.
Quote
The notes of the chord could also have two reeds each, but the thirds stop doesn't silence a reed,
it silences a complete note, including any and all reeds involved.

No.
Its not common to have only two chord reeds, if there are then there would be little point in having a stop.  To the best of my knowledge stops that operate on the chord always disable the third.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

JimJ

  • Good talker
  • **
  • Offline Offline
  • Posts: 59
Re: reeds on the bass side
« Reply #5 on: June 12, 2010, 01:29:56 AM »

Thanks, I was just on on of the manufactures sites and noticed that even on
their 2 reed boxes, the bass side had 3 reeds. Should have come back and
edited my comments.  (:)
Logged

forrest

  • Other Places::
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1009
  • digits still functioning
Re: reeds on the bass side
« Reply #6 on: June 12, 2010, 04:44:36 AM »

Thanks Steve! Very clear explanation. I wondered what the point of 'stopping' the thirds was. That makes a lot of sense. Do some people 'stop' the thirds themselves (even if the box isn't set up to do it) so that the chords can be more 'open'?

Yes, juker, that's correct. It is the subject of this thread
Logged

juker

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 838
  • Hohner 2 row G/C and C/F,
    • Julie's Art'nAll
Re: reeds on the bass side
« Reply #7 on: June 13, 2010, 09:12:43 AM »

Thanks J.W.  :|bl ....didn't realise I was overlapping with another thread!
Logged
I don't get 'jigs'

Anahata

  • This mind intentionally left blank
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6767
  • Oakwood D/G, C/F Club, 1-rows in C,D,G
    • Treewind Music
Re: reeds on the bass side
« Reply #8 on: June 13, 2010, 01:48:14 PM »

The notes of the chord could also have two reeds each, but the thirds stop doesn't silence a reed,
it silences a complete note, including any and all reeds involved.
No.
Its not common to have only two chord reeds

I think you misunderstood Jim's post - he was suggesting that there could be more that one reed per note of a chord, i.e. 6 reeds for a three note chord. As far as I know this is never done: a G major chord has one reed on each of G, B and D.

Some boxes have 3 reeds per bass note - on three different octave levels. The highest is right up in the treble range of the instrument, but it really makes the bass notes sing out and get heard from a  distance.
Logged
Слава Україні !
Music recording and web hosting: www.treewind.co.uk
Mary Humphreys and Anahata: www.maryanahata.co.uk
Ceilidh band: www.barleycoteband.co.uk

Chris Ryall

  • "doc 3-row"
  • French Interpreter
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 11154
  • Wirral UK
    • Chris Ryall
Re: reeds on the bass side
« Reply #9 on: June 13, 2010, 02:07:34 PM »

No. Its not common to have only two chord reeds, if there are then there would be little point in having a stop.  To the best of my knowledge stops that operate on the chord always disable the third.

Not on a Gaillard sapphire. With the 18 bass there probably isn't space for thirds. But having built a T+5 bass - that slider stop doesn't take much room. The mechanism is there anyway to take the low bass out and may even be a standard constuct for him.

Anyway - pushing it takes the tonic out of the dichords - leaving your bass paired with {simple 5th}.

It actually has uses and to some extent gives possibilities of many bass sounds over two octaves. You need fiendishly clever fingers and come cunning tune arrangement though!

How does your Gaillard work this Steve? or do you have the full chords version?
« Last Edit: June 13, 2010, 02:11:34 PM by Chris Ryall »
Logged
  _       _    _      _ 

forrest

  • Other Places::
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1009
  • digits still functioning
Re: reeds on the bass side
« Reply #10 on: June 13, 2010, 07:54:41 PM »


Some boxes have 3 reeds per bass note - on three different octave levels. The highest is right up in the treble range of the instrument, but it really makes the bass notes sing out and get heard from a  distance.


My Italian made Pistelli shares a 'bass' reed with the chords. The tonic of the chord is also played by the bass button by means of a lever on the bass mechanism that lifts a pallet on this reed as well as two lower octaves of the bass....
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal