I'm doing some repairs to an old French flutina style accordion, and have had to replace some of the diamonds or gussets. In doing this the original strip of leather, I think its called the top run, was disintegrating as I tried to remove it so now my plan is to replace it where needed in about a half a dozen places.
My question is how to make the 90 degree corners. I have a piece of top run leather that was supplied to me already skived. Do I make a little snip at the corner from either side toward the middle and fold over, or just fold and overlap as when wrapping a box with paper. It seems the former would be prone to leaking air but the latter would be sort of bulky. It is hard to see how it was originally done as the leather is so old.
To be honest I'm not sure if the bellows on this old instrument is different than a later melodeon. There are no metal corners and I've seen it referred to as a "bookbinder's bellows". The instrument seems to be like a cross between a melodeon and a concertina with the bellows perhaps more like a concertina.
I am new to all of this, and am trying to improve my repair techniques. Cosmetically, its already a bit compromised, though I haven't done anything that can't be reversed. My goal at this point is really to stop some leaks and improve the compression, but the original covering papers are pretty deteriorated already and don't lift off cleanly for making repairs.
Any thoughts on how to do the corners? I hope my question makes sense. Thanks, D Culgan.