Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: a cure for raspy valves?  (Read 2215 times)

0 Members and 1 Guest are viewing this topic.

tedrick

  • Guest
a cure for raspy valves?
« on: January 24, 2011, 03:44:28 AM »

Hey everyone -
I'm just about to send my Cairdin off to the tuner for a tune up and I'm asking him to look at the valves on the low end - they are just a bit raspy -- I believe they are mylar -

I would appreciate it if anyone could comment on what would be the best way to approach this sound problem - is it mainly a matter of replacing the valves? if so, would you recommend mylar, vinyl or leather?

Is it possible that it's a problem with how the reed is starting up vibration?

the box sounds good right now, but I'd like to get it sounding as good as possible --
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: a cure for raspy valves?
« Reply #1 on: January 24, 2011, 09:28:50 AM »

Replace the valves,  leather is the quietest.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Alan Morley

  • Alan Morley
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1190
    • Soundcloud
Re: a cure for raspy valves?
« Reply #2 on: January 24, 2011, 09:42:15 AM »

I was getting excited when I completly misunderstood the subject line...

I have a Peavy VK112 50 watt valve amp with raspy valves which needed a cure..just took 'em out and re-seated them...

Logged
ISIS Melodeon, Hohner Erica,  Fender Strat Plus, Takamine, Hofner Violin Bass, Hohner CX12 Harmonica, etc..

Rob2Hook

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2278
  • Castagnaris, Hohners & Baffetti
Re: a cure for raspy valves?
« Reply #3 on: January 24, 2011, 11:19:21 AM »

I used to have a radio like that!  Took the valves out, polished the legs and replaced.  Nowadays we do the same with computers that are limping along slowly, take it apart, clean the edge connector pads and reassemble.

More aligned with the original post, I have noticed that the bass valves are more prone to grumble than the treble ones, especially if I reverse the bellows without releasing the button.

Rob.
Logged

tedrick

  • Guest
Re: a cure for raspy valves?
« Reply #4 on: January 24, 2011, 11:53:59 AM »

Thanks guys -
the basses are just fine - just a little buzzy down on the lower half of the trebles -

and it would not be unusual to have leather on the lower reeds and then mylar or vinyl on the middle and higher reeds? Or can this lead to tuning issues?

R


Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: a cure for raspy valves?
« Reply #5 on: January 24, 2011, 11:57:24 AM »

and it would not be unusual to have leather on the lower reeds and then mylar or vinyl on the middle and higher reeds? Or can this lead to tuning issues?


I often do this on rebuilds,  mylar valves are more reliable on the highest notes.  I've not encountered any tuning problems.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal