Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: button height adjustment  (Read 1746 times)

0 Members and 1 Guest are viewing this topic.

Mandomentch

  • Member
  • *
  • Offline Offline
  • Posts: 21
button height adjustment
« on: February 01, 2011, 12:27:18 PM »

I have a 4-voice, 2-coupler red-badge Paolo Soprani with very low treble button height. Some players report they are better able to slide from button to button with a super low height, but I find it tough to feel the buttons as you move about the keyboard. In addition, because the button travel is so limited, I suspect the pallets are not opening enough to allow unrestricted speech. Can anyone suggest a good way to raise these glue-on type buttons? I think 2mm would help a lot.

I would greatly appreciate hearing from anyone with knowledge and experience in these matters.

Many thanks,
Robert
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: button height adjustment
« Reply #1 on: February 01, 2011, 12:34:36 PM »

Replacing the pallet facing with thinner material will do it.
The "proper" way to do it is to use a specially designed tool, rather like a pair of pliers with small dome on each face.  The tool enables you to squeeze the edge of the aluminium lever which has the effect of bending the lever in a very controlled manner.  Be working on one edge of the lever or the other it is possible to  raise or lower the button.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: button height adjustment
« Reply #2 on: February 01, 2011, 07:45:45 PM »

Thanks, Theo......using thinner pallet covering had not occured to me. Correct me if I'm wrong, but wouldn't that change the angle where the pallet meets the soundboard, resulting in a poor seal? Is it a reasonable strategy to heat the keyshaft enough to soften the wax, allowing the newly covered pallet to re-seat itself?

You are quite correct about the pallet angles, but you have to take the pallets off to replace the facing, so they get re-set when you put them back. 
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Stiamh

  • Old grey C#/D pest
  • Hero Member
  • *****
  • Online Online
  • Posts: 3611
    • Packie Manus Byrne
Re: button height adjustment
« Reply #3 on: February 02, 2011, 01:46:10 AM »

I look forward to seeing that box next time we meet, Robert  (:)

BTW with your skills as a luthier I'd have thought you could fix up accordions without too much difficulty...
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal