Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Dating my Tommy  (Read 3845 times)

0 Members and 1 Guest are viewing this topic.

Thrupenny Bit

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7232
  • happily squeezing away in Devon
Dating my Tommy
« on: February 27, 2011, 04:13:32 PM »

I've finally taken the plunge and removed the front grill.
Inside in nice handwriting is
" Castagnari DIC 2004 "
and the casing has a hand written number, I've noted for identity purposes.

Having no Italian, is "DIC" and abbreviation for month, tuner's initials .... any ideas?

I've trawled around the forum and read Steve_Freereeder's review of a Tommy done a while back. He mentions the earlier ones had 2 reeds per bass but the newer ones now has 3 reeds per base.
Has anyone any ideas whether a 2004 model is a 2 reeder or 3 reeder?

.....or tell me how to get into the bass end without upsetting anything, and describe the dirfference between 2/3 reeds!
yours in investigative mode but with no idea  :D
Q
Logged
Thrupenny Bit

I think I'm starting to get most of the notes in roughly the right order...... sometimes!

Kautilya

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 977
Re: Dating my Tommy
« Reply #1 on: February 27, 2011, 04:35:12 PM »

I've finally taken the plunge and removed the front grill.
Inside in nice handwriting is
" Castagnari DIC 2004 "
and the casing has a hand written number, I've noted for identity purposes.

Having no Italian, is "DIC" and abbreviation for month, tuner's initials .... any ideas?

I've trawled around the forum and read Steve_Freereeder's review of a Tommy done a while back. He mentions the earlier ones had 2 reeds per bass but the newer ones now has 3 reeds per base.
Has anyone any ideas whether a 2004 model is a 2 reeder or 3 reeder?

.....or tell me how to get into the bass end without upsetting anything, and describe the dirfference between 2/3 reeds!
yours in investigative mode but with no idea  :D
Q
Dont worry about not knowing Italian - if it has Al Capone written anywhere inside on the gold reed blocks  (signed would be even better, with his zip code and IRS Number) and looks as though it might squeeze into a violin case or for a full bellows "stretch" into a double bass case) then it could be worth a fortune at Sotheby;s New York >:E
Logged

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Dating my Tommy
« Reply #2 on: February 27, 2011, 04:37:11 PM »

My Tommy is an old one, 1980s, and has only two bass reeds but I would be really interested in how the newer ones have three bass reeds as there is little or no space in the bass end for the additional 4 reed plates. I have just spent some time replacing a reed on my Tommy's bass block so know how much spare space there is. Photos would be good.

3d to see the bass block you have to pull the bellows pins on the treble end and he split he box and peer down the bellows.

ps just found a picture Tommy Bass Block
« Last Edit: February 27, 2011, 04:41:52 PM by Lester »
Logged

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Dating my Tommy
« Reply #3 on: February 27, 2011, 05:01:58 PM »

I've finally taken the plunge and removed the front grill.
Inside in nice handwriting is
" Castagnari DIC 2004 "
and the casing has a hand written number, I've noted for identity purposes.

Having no Italian, is "DIC" and abbreviation for month, tuner's initials .... any ideas?

I've trawled around the forum and read Steve_Freereeder's review of a Tommy done a while back. He mentions the earlier ones had 2 reeds per bass but the newer ones now has 3 reeds per base.
Has anyone any ideas whether a 2004 model is a 2 reeder or 3 reeder?

.....or tell me how to get into the bass end without upsetting anything, and describe the dirfference between 2/3 reeds!
yours in investigative mode but with no idea  :D
Q
I'm never quite sure what the handwritten numbers inside Castagnari instruments actually mean. They are certainly not serial numbers, but may well be batch numbers from the particular maker/finisher/tuner.

To get into the bass end, you need to remove the bellows pins which, on a Tommy, are all on the treble end. There are four pins: stout round-headed brass nails. Lay a small piece of cloth or chamois leather over the pin head to avoid marking the wooden casework; grip the pin head through the cloth with a pair of pliers and pull the pin out with a straight firm pull at right-angles to the casing. Put the pins in a safe place in an ordered position so you can replace the pins in their original holes afterwards (not strictly necessary but I think it is good practice anyway, and vital when dealing with concertina end bolts which often have individually cut threads).

Once you have removed the pins, gently ease the RH end away from the bellows frame. Looking down through the interior of the bellows you will see the LH bass/chords reedblock. If you wish to investigate further you will need a screwdriver (cross-head) long enough to reach into the bellows space and remove the four screws which hold the reed block in place. Once you've done that, you can gently lift out the reed block (try to avoid touching the reeds and leather valves with your fingers), and then you will be able to see the ports which are uncovered by the pallets when you press a button.

On an earlier Tommy in order to keep the size/weight to a minimum, for each button the highest bass reed and one of the chord reeds are shared, so there will be four reeds for each combination of bass note and associated chord. From memory - which may be a bit hazy - if you play a bass note on its own, two reeds will sound. If you play a chord, three reeds will sound, but the tonic of the chord will be the same reed as the upper of the bass notes. If you play both bass note and chord together, you will still only have four reeds sounding. On more conventionally-sized instruments, there will be three independent reeds for the bass and three for the chord - six in all. Having never seen the inside of a modern Tommy, I'm uncertain whether there is any sharing going on. The Castaganri website describes the bass of the Tommy as having three reeds per note, which is still ambiguous.

Edited to add:
A 2004-built Tommy will almost certainly be a shared reed type as described above.
« Last Edit: February 27, 2011, 05:08:19 PM by Steve_freereeder »
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Dating my Tommy
« Reply #4 on: February 27, 2011, 05:06:20 PM »

Have just seen Lester's reply and photo. Yes - that is how I remember the Tommy bass reed block. As he says there is little room for additional reeds, and yet the modern Tommys are much the same size as the older ones. Can anyone else shed any more light on modern Tommys? Theo, Rees? 
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Dating my Tommy
« Reply #5 on: February 27, 2011, 05:13:18 PM »

Tommy Reed Sharing 101.

The bass end of a Tommy with the cover off.
Rod labeled 1 operates the chord
Rod labeled 2 operates the bass



So when you press the chord button rod 2 lifts the pallets A and C opening up three reed chambers



And when you press the bass botton it lifts the pallets B and C opening up two reed chambers



Therefore the reed under the C pallet is the shared reed between the bass and the chord.

Please ignore masking tape it is there to remove the thirds.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Dating my Tommy
« Reply #6 on: February 27, 2011, 05:15:49 PM »

Have just seen Lester's reply and photo. Yes - that is how I remember the Tommy bass reed block. As he says there is little room for additional reeds, and yet the modern Tommys are much the same size as the older ones. Can anyone else shed any more light on modern Tommys? Theo, Rees? 

I've only seen this type, but I've not seen inside any recent Tommys.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Dating my Tommy
« Reply #7 on: February 27, 2011, 05:56:34 PM »

Tommy Reed Sharing 101.

The bass end of a Tommy with the cover off.
Excellent, Lester! Very clear explanation, thanks.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5055
  • Windjammer
    • Wesson Accordions
Re: Dating my Tommy
« Reply #8 on: February 27, 2011, 07:21:50 PM »

I've finally taken the plunge and removed the front grill.
Inside in nice handwriting is
" Castagnari DIC 2004 "
and the casing has a hand written number, I've noted for identity purposes.

Having no Italian, is "DIC" and abbreviation for month, tuner's initials .... any ideas?


DIC 2004 is Dicembre 2004 (December 2004).
Logged
Rees Wesson (accordion builder and mechanic)
Gungrog, Welshpool, Wales, UK
www.melodeons.com

Thrupenny Bit

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7232
  • happily squeezing away in Devon
Re: Dating my Tommy
« Reply #9 on: February 27, 2011, 08:32:08 PM »

Wow - all the replies in one!
Thanks Lester, coming to my aid yet again. That is a wonderfully clear explanaition. Makes sense too.
As and when I get in there I've now got a clear picture of what I might find.

Steve - thanks too for the 'how to take off the end' instructions.
As it's almost certainly a shared reed, I think I'll leave it there until I generate sufficient courage to have another go!
...but now I know how to get in. Thanks for that.
Will take a copy of pic's and instructions for later.

....and now I know what (a ) dic is.... erm thank you for that one Rees.
I thought it seemed sensible but needed the nod.

It's amazing what you can find out when getting bored watching the rugby.
Thanks all
Q
Logged
Thrupenny Bit

I think I'm starting to get most of the notes in roughly the right order...... sometimes!

jventola

  • Member
  • *
  • Offline Offline
  • Posts: 14
Re: Dating my Tommy
« Reply #10 on: February 28, 2011, 12:14:11 AM »

Yes, the Italian for December is "Dicembre."
Logged

Malcolm Austen

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 495
  • any old hohner
Re: Dating my Tommy
« Reply #11 on: March 01, 2011, 04:42:49 PM »

Now I love my Hohner and I do take her out a lot but I would not go as far as to say we were dating, must be different with an Italian.
Logged
aka malodeon

rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5055
  • Windjammer
    • Wesson Accordions
Re: Dating my Tommy
« Reply #12 on: March 01, 2011, 05:17:42 PM »

Amore, amore, si?  (:)
Logged
Rees Wesson (accordion builder and mechanic)
Gungrog, Welshpool, Wales, UK
www.melodeons.com

Thrupenny Bit

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 7232
  • happily squeezing away in Devon
Re: Dating my Tommy
« Reply #13 on: March 01, 2011, 07:54:21 PM »

Well, down here in Devon, we lead a sheltered life.........
sometimes you have to squeeze whatever's close  :|||:

Which reminds me - practise time  ;D
Logged
Thrupenny Bit

I think I'm starting to get most of the notes in roughly the right order...... sometimes!
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal